Simple E-Kettle Setup

My project over the last month has been the control box and kettle.

 

I did several tests and charted the data to show the heating for the kettle w/o element on my stove top, just with the element and finally on the stove with the element on. The test was conducted with 5.25 gal. of tap water.

 

Looks real good. what's the element?

 

Weezy it is a Utilitech 5500w Element from Lowes its a 240v element but I'm using it at 120v due to the lack of a 240v socket in the apt.

 

1) 11 gal from Brewhardware
2) 13.5 inches
3) yes it is running at 120V
4)Utilitech Water Heater Element 5500W
Item #: 362369
5) Was planning on partial mash and all grain depending the recipie

 

Nice job. Compact and simple.

I would like to make 2 suggestions.

Replace your element with a 120v 1650W element. Your 5500w element run at 120v will result in 1/4 of the wattage for a 240v element. That takes you down to 1375W. I'm using the 1650W element with a pump and have no trouble on 15A 120V outlets.

Tie a zip tie around your power cable just inside the box. This will help prevent the cord from being pulled out of the terminal strip.

John

 

@jagabois nice thought about the zip tie, I will implement that today, i will have to look for a 1650 element. What is the watt density of the one you use. Part of the reason I chose to use a 240v element at 120v is to keep the watt density low.