Regulator extensions

Does anyone know if its possible to connect the 4 regulator kit (T1694ST) and the 2 regulator kit (T1672ST)? From looking at the pictures, each regulator has a small brass connection between them. Can I just add another one of those brass connections to make this a six regulator setup?


http://www.beveragefactory.com/draf...four_product_secondary_regulator.shtml?bstr=1

 

You can connect the two sets by splitting the incoming line with a tee or with a short bridge pipe.

 

Does anyone know where I can get a 6 regulator setup?

 

Yes, but I am not a advertiser on this site and I am not allowed to posts links to my site.

 

You could send me an email to [email protected] or a PM. That would be helpful.

 

To answer your original question. Yes, you should be able to just add a nipple and connect more regulators.

Just keep in mind that these are all low pressure secondary regulators, so you'll still need a primary at your tank to drop the 2000psi of the tank down to a usable pressure for these. Guessing you already knew that though?