Priming for different bottle sizes? | HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Homebrew Talk

Help Support Homebrew Talk by donating:

  1. Dismiss Notice
  2. We have a new forum and it needs your help! Homebrewing Deals is a forum to post whatever deals and specials you find that other homebrewers might value! Includes coupon layering, Craigslist finds, eBay finds, Amazon specials, etc.
    Dismiss Notice

Priming for different bottle sizes?

Discussion in 'Bottling/Kegging' started by agreenmartian, Nov 5, 2012.

 

  1. #1
    agreenmartian

    Well-Known Member

    Posted Nov 5, 2012
    I'm planning on splitting most of my Punkin Ale clone into one case of 1L flip tops and the remainder in standard 12oz bottles. I know that higher volume needs less priming sugar, i.e. a 5 Gal keg vs 12 oz bottles.
    Will there be an appreciable difference in carbonation if I prime the same amount in both size bottles, or should I prime and bottle the 1L and then prime and bottle the leftovers into 12oz with a slightly higher proportion of sugar?
    :confused:
     
  2. #2
    MichaelBrock

    Well-Known Member

    Posted Nov 5, 2012
    Most people add the priming sugar to the entire batch of beer at once (say 4 ounces to 5 gallons). Usually by dissolving the sugar in boiling water and adding it and the beer to a bottling bucket. The beer is mixed with the sugar solution, usually in the process of siphoning the beer into the bucket, and then dispensed from the bottling bucket to the individual bottles. With this approach you do not need to be concerned with the size of the bottles you put the beer into.
     
  3. #3
    tektonjp

    Well-Known Member

    Posted Nov 5, 2012
    Use the same. I use the same when I prime kegs. Never any problem or over carbonation.
     
  4. #4
    agreenmartian

    Well-Known Member

    Posted Nov 5, 2012
    Thanks! :mug:
     
  5. #5
    Kealia

    Well-Known Member

    Posted Nov 5, 2012
    There will be a noticeable difference if you use the same amount of priming sugar in 33 ounces and in 12oz. If you don't have a bottling bucket, now might be the time to get one as it solves the issue of multiple bottle sizes.

    If not, here is one of many similar calculators that should help you determine how much priming sugar to use.
     
  6. #6
    agreenmartian

    Well-Known Member

    Posted Nov 5, 2012
    I have a bottling bucket, I was actually wondering if I needed to do two rounds of bottling. One with a lower proportion of sugar for the 1L, and one slightly higher for the 12oz so the 1L bottles aren't more carbonated than the 12oz. But if one proportion of sugar will work fine for both then I'll just do one round of priming/bottling.
     
  7. #7
    Kealia

    Well-Known Member

    Posted Nov 6, 2012
    Yep, just prime the whole batch once and then bottle it. Then it doesn't matter what size bottles you use.

    Cheers.
     
  8. #8
    Revvy

    Post Hoc Ergo Propter Hoc  

    Posted Nov 6, 2012
    You just prime the whole batch and fill your bottles. Just be aware that it tends to take LONGER for larger bottles to carb and condition in relation to 12 ouncers. It may take a week or two MORE for the bigger bottles to come up to snuff.
     
    lelandmccann likes this.
Draft saved Draft deleted

Share This Page

Group Builder