Initial Water Temperature being added to Brew Pot, does it matter? | HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Homebrew Talk

Help Support Homebrew Talk by donating:

  1. Dismiss Notice
  2. We have a new forum and it needs your help! Homebrewing Deals is a forum to post whatever deals and specials you find that other homebrewers might value! Includes coupon layering, Craigslist finds, eBay finds, Amazon specials, etc.
    Dismiss Notice

Initial Water Temperature being added to Brew Pot, does it matter?

Discussion in 'Beginners Beer Brewing Forum' started by Sippin37, Dec 5, 2011.

 

  1. #1
    Sippin37

    Well-Known Member  

    Posted Dec 5, 2011
    So I normally do 2.5-3 gallon partial boils and then top off to 5 gallons in the primary but I have heard from several people that doing a full 5 gallon boil makes a HUGE difference. I am using an aluminum 7.5 gallon pot so there is plenty of room to do a full boil. Unfortunately I am still using the gas range on my oven but it seems to get up to a full boil with the lid mostly covering the top.

    My one concern is that I add tap water on the coldest setting (thinking this is the cleanest form of water) and about 10-15 minutes after turning on the gas burner a lot of condensation forms on the side of the pot and trickles down into the burner and then scorches my oven top. I'm in Chicago only about 3 miles from Lake Michigan so our tap water is really cold year round. Is it okay to turn the tap water to a warmer temp when filling my brew pot to 5 gallons to try avoiding the condensation on the side of the pot? Or even adding the hottest possible tap water to the brew pot initially? I had always thought this would make the water not as clean, but since I was going to be bringing to a boil eventually, does it matter?

    Thanks for any input, just thought I'd see if anyone had some words of advice before I ruin a 5 gallon batch! :D
     
  2. #2
    Snicks

    Well-Known Member

    Posted Dec 5, 2011
    Well it would only be as clean as your hot water tank... maybe the water will have a little more iron than normal.

    I actually use hop tap water all the time when I'm getting my second round batch sparge water ready, but only since I got a new tank earlier this year. When I drained the old one there was probably a foot and a half of rusty sludge on the bottom of it, probably not too good for brewing but I'm not really sure.
     
  3. #3
    DSmith

    Well-Known Member

    Posted Dec 5, 2011
    You want unsoftened water if you have one of those. That would mean to avoid all hot water sides of facuets. If the water pipes are exposed in the basement, it's easy to determine if any of the faucets in the house have unsoftened cold water.
     
  4. #4
    Sippin37

    Well-Known Member  

    Posted Dec 6, 2011
    Ok great, thanks for the information guys. You reassured exactly what I was thinking on the subject.
     
Draft saved Draft deleted

Share This Page

Group Builder