Cleaning kegs that held cooking oil | HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Homebrew Talk

Help Support Homebrew Talk by donating:

  1. Dismiss Notice
  2. We have a new forum and it needs your help! Homebrewing Deals is a forum to post whatever deals and specials you find that other homebrewers might value! Includes coupon layering, Craigslist finds, eBay finds, Amazon specials, etc.
    Dismiss Notice

Cleaning kegs that held cooking oil

Discussion in 'Bottling/Kegging' started by Carros, Dec 3, 2013.

 

  1. #1
    Carros

    Supporting Member  

    Posted Dec 3, 2013
    I found some decently priced corny kegs on craigslist. The ad says they were used to hold cooking oil previously though. I'm thinking a good oxiclean soak should get them clean enough to hold beer in, but wanted to check on here to see if anyone had experience with cleaning this type of stuff out of a keg.

    Thanks
     
  2. #2
    MachineShopBrewing

    Well-Known Member

    Posted Dec 3, 2013
    You will need some kind of degreaser like a dish soap. Then rinse, rinse, rinse, rinse, and rinse again. Then I would hit it with some Oxy, rinse and then acid sanitizer. That should do it.
     
  3. #3
    JuggaChef

    Member

    Posted Dec 3, 2013
    I use to use Sysco oil containers cuz they are 5.5 gallons. I stopped for one its plastic. (Porous) and you can never get all the oil out. Doesn't make the mead gross or anything, just a lot better off with a glass carboy or brewing bucket.
     
  4. #4
    Epimetheus

    Well-Known Member

    Posted Dec 3, 2013
    It is better to use a degreaser rather than an oxidizer like Oxy-something. Your best bet is TSP (tri sodium phosphate) or TSP 90 (without the phosphorus for environmental reasons). Hot water helps.
     
  5. #5
    Stealthcruiser

    Supporting Member  

    Posted Dec 3, 2013
    Simple Green will degrease them well, then follow up with several GOOD, hot rinses, then a PBW or Oxi-Clean wash.
     
  6. #6
    BigFloyd

    Well-Known Member

    Posted Dec 4, 2013
    This is what I'd do. Just dilute the Simple Green in accordance with the instructions on the bottle and don't leave it sitting in there for a long, long time before rinsing it out.
     
    Stealthcruiser likes this.
  7. #7
    benj

    Active Member

    Posted Dec 4, 2013
    I'd bet that Dish Soap, hot water, a sponge and some elbow grease would do the trick. Just scrub several times and thoroughly rinse. When oil is stored in some kinds of plastic containers it never seems to come off, but dish soap should be adequate for metal surfaces. You do want to use a detergent though, other types of cleaners won't be very effective. Detergents are amphiphilic (sp?) and are therefore able to dissolve in both non-polar substances (the oil) and polar substances (the water), allowing them to wash the oil away.
     
  8. #8
    Hello

    Well-Known Member

    Posted Dec 4, 2013
    Dawn. It gets oil off marine animals, it'll get oil out of a keg I would think.
     
    Stealthcruiser likes this.
  9. #9
    Renoun

    Well-Known Member

    Posted Dec 4, 2013
    There is a Simple Green Crystal that is formulated without dyes and perfumes that might be a more appropriate degreaser than regular Simple Green. It's used fairly frequently for cleaning equipment exposed to high pressure oxygen service which isn't very forgiving of contact with hydrocarbons.
     
    Stealthcruiser and wnilesrumford like this.
Draft saved Draft deleted

Share This Page

Group Builder