Black mold

I just looked into an Ale Pail that's been sitting in the basement for a few weeks and saw some spots of black mold on the bottom. I guess it was still wet when I put it away, and I had it covered. I wiped it out and filled it with sanitizer, but now I'm wondering if using it is just asking for trouble. Thoughts?

 

Nah, it will be fine. I would recommend cleaning it with either PBW or even just some soap and water and wiping thoroughly with a sponge. After it is properly cleaned you can then sanitize.

 

I think the StarSan should kill any of the mold it comes in contact with. The key is it has to come in contact with it, meaning if there was some film or debris left on the surface, the StarSan may potentially not reach it.

 

Thanks for the quick replies!

 

I've had mold in my fermenters too when brew day comes. I oxi everything vigorously morning of and then sanitize and that completely gets rid of the mold. I too am paranoid about sanitizing however.

 

I've let star San soak in the moldy bucket for a couple weeks and then rinsed with hot water several times after a mold problem. It's normal brew day sanitation after that, and have had no issues. I leave my equipment in our three seasons room to dry now before storing in the basement. Kyle

 

Plastic is a non porous material. Scrub scrub scrub, disinfect and sanitize and you should be just fine. I mitigate mold for a living.

 

Honestly, what's more concerning is the fact that you got mold on a plastic surface to begin with. I would clean and sanitize any brewing equipment before storage to clean out any food sources for mold.