3/8" barbed ball lock gas & Beer disconnect ? | HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Homebrew Talk

Help Support Homebrew Talk by donating:

  1. Dismiss Notice
  2. We have a new forum and it needs your help! Homebrewing Deals is a forum to post whatever deals and specials you find that other homebrewers might value! Includes coupon layering, Craigslist finds, eBay finds, Amazon specials, etc.
    Dismiss Notice

3/8" barbed ball lock gas & Beer disconnect ?

Discussion in 'Bottling/Kegging' started by wstandis, Dec 13, 2008.

 

  1. #1
    wstandis

    Active Member

    Posted Dec 13, 2008
    I am almost done with my glycol system. i had to buy the 3/8" id tubing and was wondering how I am going to connect it to the ball lock? Any ideas?

    i could do a splicer to a 3/16 line but would rather not.
     
  2. #2
    BargainFittings

    Vendor / Owner  

    Posted Dec 13, 2008
    If your ball lock connectors are the type with hose connectors built into them the only real solution is the splice.
     
  3. #3
    wstandis

    Active Member

    Posted Dec 13, 2008
    i WOULD BUY NEW IF THEY MADE THEM WITH 3/8 BARB?
     
Draft saved Draft deleted

Share This Page

Group Builder