Anyone have any experience with Urethane finishes? - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Community > General Chit Chat > Anyone have any experience with Urethane finishes?

Reply
 
Thread Tools
Old 10-27-2008, 12:46 AM   #1
Sea
Green Flash IPA on tap
HBT_LIFETIMESUPPORTER.png
 
Sea's Avatar
Recipes 
 
May 2007
Southern Oregon
Posts: 1,478
Liked 6 Times on 6 Posts



I've got a built-in poplar shelf that has been partially finished with polyurathane. I'm wondering if I can, after a good sanding, finish it with a water based, urathane fortified finish, specifically Sickens Cetol BL. Will there be any issues between these two finishes? Both are clear natural finishes.
__________________
I plan on living forever. So far, so good! - unknown.


Corrupt Brewers

 
Reply With Quote
Old 10-27-2008, 01:02 AM   #2
r2eng
 
r2eng's Avatar
Recipes 
 
Mar 2008
Eagle, Idaho, Idaho
Posts: 1,476
Liked 33 Times on 28 Posts


water-based is OK over poly... it will not lift the finish below. However, make sure you sand really good and start with light coats. Water based finishes tend to bead when on cured finishes.

Keep me posted how it goes.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Took a couple of 3rd Place finishes in this years homebrew competition Medo General Beer Discussion 7 08-04-2009 10:44 PM
Noobie finishes two batches wants to start another 1EightT Extract Brewing 12 09-12-2008 02:13 PM
Coupling Spyder Material-Buna Or Urethane? HenryHill Equipment/Sanitation 1 04-02-2008 11:27 AM
My ESB finishes too bitter! hoplobster All Grain & Partial Mash Brewing 13 09-22-2007 01:26 PM
First AG experience jezter6 All Grain & Partial Mash Brewing 10 12-28-2006 09:01 PM


Forum Jump