Phase 2 brewery boiler testing - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > Phase 2 brewery boiler testing

Thread Tools
Old 10-18-2008, 02:47 AM   #1
Senior Member
Dec 2006
Turner, Oregon, Oregon most of the time now
Posts: 2,305
Liked 54 Times on 47 Posts

Have finally beat PID code into submission and hit target operation for strike water heating @ .5GPM, here is a chart Picasa Web Albums - Kevin - Boiler Test, here is the boiler Picasa Web Albums - Kevin - New Boiler an.... Next goal is the boiler water and wort flow control loops then steam/wort mixer temperature control. After loop tuning is finished the final testing with malt and sequence control, then test run with full size mash to see if all the design features work and target gravity is reached. The design goal with the boiler is to heat strike water, sparge water, and make steam for step mashing. With the flash boiler it should be possible to dough in with less than 10 minutes needed from cold start to finish, and make mash temperature steps of up to 50 degrees in about 10-12 minutes.

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Phase 2 brewery build progress shots kladue Brew Stands 207 05-24-2011 04:37 AM
Attenuative phase radtek General Techniques 4 04-24-2009 04:40 PM
PH testing and Starch Testing. Orfy All Grain & Partial Mash Brewing 18 03-28-2009 05:28 PM
Phase 2 brewery construction photo kladue Equipment/Sanitation 35 07-24-2008 05:34 PM
Electrical help for last phase Brewpastor Brew Stands 23 04-04-2007 02:57 PM

Forum Jump