Home Brew Forums > Home Brewing Beer > Bottling/Kegging > Neoprene Washer
Reply
 
Thread Tools
Old 10-03-2008, 09:45 PM   #1
MGR72
Feedback Score: 0 reviews
Recipes 
 
Join Date: Jun 2008
Posts: 10
Liked 1 Times on 1 Posts

Default Neoprene Washer

Hey there. I'm putting together my Kegging system in a refrigerator finally. I got 1/4 ss shanks from Micromatic along with some Perlick faucets from Superior Products.... I'm very excited to have it all set up to say the least. When ordering from Micromatic I got the neoprene washers that it says are required with the shank and nipple assembly. Problem is, I can't figure out where they go in the system..... it seems like it would go between the nipple and shank in order to seal that connection when it is tightened down with the nut but it doesn't really fit very well. Anyone got some ideas? Thanks in advance.
-W



MGR72 is offline
 
Reply With Quote
Old 10-03-2008, 10:31 PM   #2
chillHayze
Feedback Score: 0 reviews
 
chillHayze's Avatar
Recipes 
 
Join Date: Mar 2006
Location: Columbus OH
Posts: 1,589
Liked 7 Times on 7 Posts

Default

That connection should seal on the flats, where the washer goes, so you are correct. If it is tight you can trim it, but if too small then you need to have them send you one that fits!
__________________
RDWHAHB
Every little thing is gonna be alright.

chillHayze is offline
 
Reply With Quote
Old 10-03-2008, 11:16 PM   #3
MGR72
Feedback Score: 0 reviews
Recipes 
 
Join Date: Jun 2008
Posts: 10
Liked 1 Times on 1 Posts

Default

Well, just put it together and made it fit.... for anyones future reference in order it was assembled beerline--nipple--nut--washer--shank--faucet. No beer to pour yet but water pushes out of the keg just fine!

And on an unrelated note, thank you all, I have been lurking on these boards mostly but have been soaking up so much information.... I'm excited to get this kegging system all set up so its easier to brew more and more!
MGR72 is offline
 
Reply With Quote
Reply


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Do I need a washer? timmystank Bottling/Kegging 3 08-05-2009 04:51 PM
My New Keg Washer mZnthebend Equipment/Sanitation 7 04-05-2009 11:12 PM
regulator - need washer? boogyman Bottling/Kegging 1 02-17-2009 03:49 AM
Are neoprene washers food-safe? Hercules Rockefeller Equipment/Sanitation 9 07-17-2008 02:55 PM


Forum Jump

Newest Threads

LATEST SPONSOR DEALS