Coldbreak Brewing Giveaway - Open to All!

Home Brew Forums > Home Brewing Beer > Bottling/Kegging > kegconnection tower kit and sanyo 4912
Reply
 
Thread Tools
Old 09-22-2008, 04:23 PM   #1
quixotic
Feedback Score: 0 reviews
Recipes 
 
Join Date: Feb 2008
Location: Bay Area, CA
Posts: 238
Liked 1 Times on 1 Posts

Default kegconnection tower kit and sanyo 4912

Question for those that have used the kegconnection kit with the Sanyo:

I cannot for the life of me find t nuts that fit the metric machine screws from the kit. Checked Home Depot, Osh, and Ace. I thought about using 1/4'' machine screws and t nuts, but they don't fit through the holes in the tower. I've got 1 more store to check, but if they don't have the metric t nuts, I'll have to switch to a smaller size bolt.

What bolts/t nuts have people used? Will a wood screw without a t nut do the job? Is there a good length to use so that I don't have to trim the end of the screw?


__________________
Bridger Brewing Co.
primary
: Belgian wit
secondary:oatmeal stout
kegged: marzen
on tap: apfelwein
on tap: Northern Brewer/Vienna SMaSH
on deck: beer
quixotic is offline
 
Reply With Quote
Old 09-22-2008, 07:50 PM   #2
MoRoToRiUm
Feedback Score: 0 reviews
Recipes 
 
Join Date: Jun 2008
Posts: 1,413
Liked 4 Times on 4 Posts

Default

Not quite sure which ones you are referring to; If you're talking about the screws for the tower that go into t-nuts inserted into wood back plate, you can always get new bolts sized with the right t nuts at any home supply store. Take them both in and start sizing/screwing (Advise your local store or Home Depot, Lowes has everything in bags).

As far as the length, if you are using a 1/2' wood back plate, 5/8 or so should work (I got long ones, and shortened them with my wire cutters before installing). A lot of people use a hacksaw blade for shortening once they are screwed in, but I would advise a Dremel with a metal cutoff.
MoRoToRiUm is offline
 
Reply With Quote
Reply


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Sanyo 4912 draft tower stabilization mod and stainless steel rail install tips sirsloop Bottling/Kegging 16 10-20-2012 02:24 AM
Sanyo 4912 vs. Sanyo SR-4912M jay29 Equipment/Sanitation 9 03-07-2011 05:31 AM
Tower for Sanyo 4912 StankAle Equipment/Sanitation 24 01-23-2011 07:44 PM
Sanyo 4912 FireBrewer Bottling/Kegging 6 07-20-2007 08:31 PM
sanyo 4912 roryspa Bottling/Kegging 55 05-09-2007 03:40 PM


Forum Jump

Newest Threads

LATEST SPONSOR DEALS