Rig Plumbing/Mounting - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > Rig Plumbing/Mounting

Thread Tools
Old 04-15-2008, 08:14 PM   #1
Jan 2008
Austin, TX
Posts: 420
Liked 4 Times on 3 Posts


I'm setting up to get the rig built this week. I searched in vain of a parts list on here but I've got a good idea of what to build. It will be a thin, three tier with two burners mounted at the top and the bottom (middle is MLT)

My main question, though is that if it's ok to use 1/2" black iron piping for the LP gas feed(all parts are 1/4", haven't seen any 1/4" black iron pipe).

I don't want to use long propane hosing but rather get exact sizes for the piping. Then again, I may stupid in trying that. Either way, what should I use to distribute the propane to tower?

Lastly, those with banjo burners, how far did you mount from the top?

Thanks in advance.

Landed In Texas.
Primary 1: Blonde?(9/14/2013)
Primary 2: Empty
Sanke madness!
Sanke Spiral Ring Installing, Sanke Coupler diassembly, Keggle Heatshield, Sanke fitting to Soda kegs

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Mounting jet burners donshizzles Brew Stands 1 07-30-2009 03:56 PM
Mounting magnets ClaudiusB Chillers & Stir Plates 2 04-17-2009 04:15 AM
Need help mounting propane plumbing for Brewstand Dustin_J Brew Stands 5 02-21-2009 08:47 PM
plumbing help SHF DIY Projects 3 10-14-2008 05:56 PM
mounting co2 manifold...?? Jester Bottling/Kegging 5 04-11-2006 06:08 PM

Forum Jump