Hello
So here is my original thread from 2013/2014:
https://www.homebrewtalk.com/showthread.php?t=440903
The last photo in that thread was where I finished up and all worked great.
Fast forward a couple of years and I have moved house. I have the same dryer outlet, 3 prong, 30a circuit so I figured I could just plug and play as before.
However, I plugged in the spa panel and switched on my controller and the display flickered and the spa panel tripped.
Now, whenever I plug in the spa panel it immediately trips, even if I have nothing connected to the outlet from the spa panel.
I opened it up and all the connections still look good. Photos attached.
Can anyone provide some pointers here? It's a 3 wire input (white receptacle at bottom) going to a 4 wire output.
So here is my original thread from 2013/2014:
https://www.homebrewtalk.com/showthread.php?t=440903
The last photo in that thread was where I finished up and all worked great.
Fast forward a couple of years and I have moved house. I have the same dryer outlet, 3 prong, 30a circuit so I figured I could just plug and play as before.
However, I plugged in the spa panel and switched on my controller and the display flickered and the spa panel tripped.
Now, whenever I plug in the spa panel it immediately trips, even if I have nothing connected to the outlet from the spa panel.
I opened it up and all the connections still look good. Photos attached.
Can anyone provide some pointers here? It's a 3 wire input (white receptacle at bottom) going to a 4 wire output.