We've got a 3 tap keezer at work. There are flow sensors in the lines. Everything was fine for quite a while, but now one of the taps has really started foaming. It's not even that it foams while your pouring, per-se. It's almost pre foamed.
You can see it after you finish pouring if you watch the line. it starts filling up with bubbles as it's sitting there. It's almost as if the beer is leaking out allowing room for the co2 to come out of the beer. This would seem to indicate there is a leak in the line, however no beer is leaking out.
Anyone have any ideas?
You can see it after you finish pouring if you watch the line. it starts filling up with bubbles as it's sitting there. It's almost as if the beer is leaking out allowing room for the co2 to come out of the beer. This would seem to indicate there is a leak in the line, however no beer is leaking out.
Anyone have any ideas?