Real Ale in Pins is not for the faint of heart! - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > General Techniques > Real Ale in Pins is not for the faint of heart!

Thread Tools
Old 10-02-2013, 02:30 AM   #1
Oct 2012
Watertown, MA
Posts: 60
Liked 5 Times on 5 Posts

An amusing event *almost* happened this evening and I thought that some of you out there might appreciate it. I'm a big fan of real ale, especially real ale (commercial or homebrew) done on gravity from a pin (4.5 UK gallons) or firkin (9 UK gallons). I have a bit of experience as the Head Cellarman of the past couple of New England Real Ale eXhibitions. You'd think that this would make it easier to do at home but read on..

I'm preparing a pin of my Best Bitter for a Casktoberfest event in a couple of weeks. No biggie. I brewed a 10 gallon batch, let it ferment, then racked 5.2 gallons into my pin and put the rest into a corny. Standard priming rate of 1.2 oz of table sugar. Everything seemed set. Chocked it at 3-9 (keystone at 3 o'clock, bung hole at 9 o'clock, keeps 'em both wet which gives a better seal). Four weeks to go. No problem.

Three weeks to go. No problem. Slight beer aroma from my brewing area, but it's a brewing area.

Two weeks to go. Why does that nylon bag look like it's been wicking up beer? Closer investigation reveals a contained puddle beneath the pin that's starting to expand. Bummer. I move the pin out of the way and begin the clean up. There's a bit of hissing (along with a bit of mold) near the shive, indicating the source of the seepage. It happens. I continue cleaning.

While mopping (and halfway across the room) I hear a *PING*. My shive had popped halfway out but caught itself. Had it kept going it would have been a blown shive, beer all over the floor, a lost batch. With two weeks until the event what remained probably wouldn't have been worth saving. All because the beer gods smiled, came down to my pin, and stopped the shive. Oh, and did I mention that this was at 10:PM as I was headed up to bed?

I paused the cleaning to vent the pin (put a hole in the shive to allow the excess gas to escape), then went back to mopping. Final resolution was to replace the shive. Beer still looked & smelled good. I had lost maybe 1/2 a gallon. Still plenty of beer in there, especially with excessive CO2 taking up the headspace. I took the opportunity to pop in a plug of Fuggles that I had forgotten to put in when filling. It's now back at 3-and-9 with no seepage.

Examining the shive, it looks like a sliver of plastic from the bottom had gotten shaved almost off, then caught and wedged vertically along the rubber that was supposed to seal the pin. Such a tiny thing. These things happen with real ale. Especially in the middle of the night at my house.

Reply With Quote
Old 10-03-2013, 01:17 AM   #2
Feb 2013
Posts: 115
Liked 12 Times on 11 Posts

Haha, it's worth it though. Drinking uk ales through an engine is magic!. One of the ex pats here in aus bought a few plastic ones back from the uk. Worked ok, bit diddly though. Now at our real ale festivals we just use cube shaped water containers with a screw cap ( no chill cube ). Rack our ale into them with some priming sugar ( not a lot obviously!! ). Wait a week then we all take them to the hosts place. Chill on ice ( not too cold ) then run through a few engines. Personally these events are our brew clubs best!!.

Reply With Quote
Old 10-03-2013, 01:41 AM   #3
Nov 2004
Posts: 2,621
Liked 205 Times on 171 Posts

Kudos for the work you put in at NERAX, my favorite beer event.

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
It's official, I'm having heart surgery on Feb, it's real now. Revvy General Chit Chat 762 02-22-2015 06:58 PM
Fruit Beer Insanely Lemon Hefeweizen (Not for the faint of heart) MetalMatt Specialty, Fruit, Historical, Other Homebrew Recipes 5 04-05-2013 03:35 AM
Have you ever... [not for the faint of heart] Golddiggie Drunken Ramblings and Mindless Mumbling 21 01-04-2013 06:33 AM
You ever notice --not for the faint of heart-- Golddiggie Drunken Ramblings and Mindless Mumbling 43 11-29-2012 02:12 PM
My build, not for the faint of heart BenjaminR Kegerators & Keezers 26 06-17-2009 06:25 PM

Forum Jump