Originally Posted by campy5863
Here's my problemo: I now need to "plumb" black pipe for the gas to feed both burners and have never worked with black pipe nor gas for that matter!
Is there a video, or step by step intructions out there on how to do this?
I know Blichmann has some instuctons, but doesnt really give many details for the gas pipe installation. I apologize if this has been covered, but I have been searching extensively since I buying this rig, and I cant seem to find much of anthing that pertains to this. Campy
I have not looked at these recently, but there are several videos put out by Blichmann that are on You Tube. They may have one that covers this topic.
Before your purchase your black pipe, you will want to purchase the burner (or burners if you are buying two) from a vendor. You will want the burners for the Top Tier Stand and NOT the floor burner. Although the burners in each kit are exactly the same, the burner for the Top Tier stand has ALL the hardware you will need to attach the burner to your Top Tier. It will also have the Stainless Steel gas line and needle valve to run from the manifold to the burner. These items are not included in the Floor Stand kit.
After you get your burner(s) you will want to determine what your configuration will be. You can have two low on the same level and one high, you can have three tiers, etc. The reason for this is that it will give you an ideal of what your manifold will look like and what pieces you will need. Take some measurements to find our how long your pipes need to be. Put your Tee's at the bottom burner and middle burner. You can have elbows on the bottom (from the propane cylinder to where the propane hose attaches) and you can have an elbow at the top burner where your gas line attaches to the manifold and the needle valve (I am assuming either a two or three burner configuration).
Once you have your dimensions, you can go to Lowes or Home Depot and buy the Black Pipe (make sure that it is black pipe) in the lengths that you need. Common lengths are 1 inch, 3 inch, 8 inch, 12 inch, 24 inch, etc. Pick out the pieces that you need; you might also buy a few extra pieces that you may plan on returning if you are not sure about everything that you need.
You will need a couple of pipe wrenches and you will need some pipe dope. I used a semi liquid pipe dope for all my connections. You can get by with some tape (on the yellow spool), but make sure that it is tape for gas connections and not the Teflon tape for water connections (on the blue spool). If using pipe tape, you will want to install a couple of revolutions on the pipe thread. Install it on the thread so that the tape will tighten up as you install the pipe and the fitting. If the tape loosens up as you install the fitting, run the tape in the other direction.
I would have something like this (bottom to top)
Propane Hose to Brass Fitting
Brass Fitting to Black Elbow
Black Elbow to 6 inch nipple (black pipe)
6 inch nipple to black Tee
Black tee to 24 inch nipple (black Pipe) -- for bottom burner
24 inch nipple to Black Tee -- for Middle Burner
Black Tee to 24 inch nipple
24 inch Nipple to Elbow (for Top Burner)
Elbow to Brass Fitting
Brass Fitting to Stainless Gas Line
Please note that each fitting is mentioned twice in the above list.
Your bottom and middle Tees (if you have three burners) will each have the brass fitting installed in the odd side of the Tee. The Nipples would be in a straight line on the Tees.
This is an idea, and the actual number of pieces and lengths will depend on how you arrange the burners. Assembly of the manifold is really rather straight forward -- but use your gas pipe dope or pipe tape (I think both are available to Lowes/HD.
Doing this you should be fine.
I hope that this helps.