Auber SYL 2352 Setup - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Automated Brewing Forum > Auber SYL 2352 Setup

Thread Tools
Old 06-28-2013, 12:35 AM   #1
Dec 2012
Posts: 434
Liked 40 Times on 19 Posts

I recently completed wiring a control box for a RIMS system with an Auber PID maintaining my mash temp with a 1500w heating element. There are a ton of nonintuitive settings on this thing and I have no idea what to do with them. Does anyone have a list of settings I could use to set up this PID to control my mash? Any help much appreciated.

Reply With Quote
Old 06-30-2013, 09:03 PM   #2
Feb 2012
Anderson, SC
Posts: 31
Liked 1 Times on 1 Posts

I am in the middle of a similar build that also uses the Auber SYL-2352 and can't find a good list of settings either. This is what I have gathered from other threads, but I have the feeling that this isn't a complete list:

Run "autotune" using water that is within 10 degrees of your expected normal mash temp.
Pv: current temp of probe
Sv: desired temp of probe
Sn: 21
Cool: 10
Pb: temp offset - used to calibrate the temp probe + For each degree your probe measures too high, use -1, -2, etc - and vice-versa
Filt: 5
Alm1: Temperature alarm - sounds if you get too hot

Are these the only settings that I need to change and are these settings correct for a 1500w RIMS tube with pump?

Reply With Quote
Old 07-05-2013, 03:36 PM   #3
Nov 2009
Asheville, NC
Posts: 2,827
Liked 48 Times on 41 Posts


Reason: I was trying to start a new thread and pressed the wrong button.

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
auber 2352 HellBentBrewCo Electric Brewing 1 09-30-2012 01:23 AM
Auber PID SYL-2352 bbrim Electric Brewing 2 02-19-2012 03:24 AM
Help with Auber 2352 bendavanza Electric Brewing 3 08-16-2011 07:38 PM
Help with Auber 2352 PID Navy_Brewer Electric Brewing 0 04-05-2011 07:38 PM
Auber SYL-2352 setup question pp270 Brew Stands 12 03-04-2010 11:56 PM

Forum Jump