It has been a while since I have done any AC wiring, but did up a schematic for my new control panel. Just wondering of someone could take a look, and see if any issues jump out.
The input right now is 110, however I have wired it as to make a 220 upgrade as easy as connecting internally to the plug, changing a bulb, and removing a jumper. The element wire is currently using a red/black. The red terminal has been jumpered to the neutral terminal to keep it 110. There is NO 220 brought into the panel at this point, even hooking a 220 plug would not travel through the connector into a terminal.
-I have wired in a emergency off using a mushroom NC switch.
-I have run my contactor element relay control through my pump switch to ensure that it is not operable unless the pump is also running.
My second PID is currently temp disp only.
It is setup now to control my RIMS, yeah I know, overkill, but I wanted it to grow with my system.
all plugs are twist lock, and do not have live male prongs
Please let me know what you think
Uploaded with ImageShack.us