Hope someone is able to help me. I'm nearly complete with my stand (see my signature). But i'm running into a few issues getting my PIDs working. I have never wired anything other than installing a new light fixture, switch, or outlet.
So, i'm building a system very similar to a lot of other posted on this forum. I have Auber style PIDS with RTD sensors. I'm running a LPG system with Honeywell valves. What i want, is that when the PIDs are on and sending current to the valves that first the 110VAC current run through a LED before hitting the transformer and going to the valve.
Link for the PID
What i'm not sure of...
1. Which on/off mode do i want to run the PID in?
The PID has two on/off modes. Option 3 which will run 120V out the relay PINS and 1120 out of "j1" for an alarm. Option 4 which disables the relay outlet and send the 120V current out of the J1 terminals. How should I wire the PID with jumper going to which terminals?
2. Which wiring diagram do i need to follow.
This will help me troubleshoot on my own.
I have been troubleshooting for a few days and i'm not really making progress.
Thanks everyone, Hope someone can help.