These are left over from my electric brewery build. I have 3 MYPIN TA4 PID temp controllers and 1 Sestos B2E timer. The reason that I did not use them in my build was that the temp controllers were single alarm and I wanted a dual alarm and the timer because I bought a one that matched my new PIDs. My loss could be your gain if you are looking for these features. These were installed and powered on and hooked to RTds for testing, but were not used for a full brew day.
ual display for Fahrenheit(F) and Celsius(C).
12.Individually programmable PID control parameters.
13.P, I, d, controlling period, digital filter coefficient, and more (for control theory experts only)."
2.Range:-1999 to 9999 (depends on the input signal).
3.Main output:Relay,Normal open, AC 250V/3A DC 30V/3A COSphi=1.
4.PID cooling/heating control( can choose normal alarm output by software).
5.Alarm Output:1 RELAY:capacity AC 250V/3A DC 30V/3A.
6.7 different Dual Output.
8.Input:Thermo Resistor:PT100, Cu50.
9.Thermocouple:J,S,K,E,Wre3 ~ Wre25.
-DIN(48X48mm) Digital timer
-0.01s-99h99m time range with twin timer set value individual,
-output for A, B period
-One shot or cycle time mode, up or down mode
-NPN and PNP input switchable
-Tact switch for up or down set value, easily operate
-Key lock function, prevent mistake operation
-Power: AC 110-240V
-Input singal: Pause, Reset
-Output: 2 Relay
The PIDs you can get on ebay for $20-25 and the timer was $30.
I am looking to let them go for $15 a piece or $50 for the set. If interested please shoot me an email [email protected]
then we can figure out shipping as well. I figured I'd give you first dibs otherwise after a week Ill be posting on ebay. Cheers!