I have three "Like New" Ascon, 1/8 DIN, Gamma Due Series, X1, PID Temp Controllers. They are 100-240 VAC and have 3 relay outputs. These are large 48mm X 96mm and are extremely versatile. These can be used in connection with relays and various switching devices to control just about anything including burners, elements, motors and most any electrical devices. PID's can be programmed in software the downloaded to PID's or directly from PID. These PID's will accept various temp sensors.
also included is a "matching" Ascon 1/8 DIN J1 Temperature Display/Alarm with K thermocouple. (Could be used to monitor fermentor and sound alarm if temps are out of range as well as giving a visual of actual temp without opening door)
Use Part number below to decode specific features of the PID's I am offering by looking at the Manual Link Below.
P/N - X1-3100-0300/HHA
All the information you need can be found here-
two PID and the alarm unit come in the original package including manual, and resistor for input matching. I want to sell all as a package as I only have one serial cable and copy of software to include.
one PID, with manual and resistors, is mounted in a weatherproof workbox, with an SSR to the heater outlet and manual independent pump outlet, locking weather rated thermocouple cable, weather proof power cable. Also included is a new 110V water heater element, stainless steel locknut with O ring for the element,waterproof temp sensor and 1/2" copper T manifold for plumbing into your HERMS coil
2 of the three controllers as well as the alarm/display unit have never been used. The controller mounted in the workbox has been used twice, together as a unit. I have not programmed the unit to read the proper values with the temp sensor included, and frankly everytime I go into the manuals I get cross-eyed... simply too technical for me.
I'm selling as a package only, $200 takes everything