Ever cut slots in your MonsterMill shield for setscrews? - Home Brew Forums
Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > Ever cut slots in your MonsterMill shield for setscrews?
Cool Brewing Corny 5G & Mini Giveaway
Sign-up To NEW HBT Article Newsletter - Brewing Articles Direct To You!

Reply
 
Thread Tools
Old 02-16-2013, 04:38 PM   #1
dcbw
HBT_LIFETIMESUPPORTER.png
Recipes 
 
Join Date: Feb 2012
Location: Minneapolis, MN
Posts: 268
Liked 28 Times on 23 Posts

Default Ever cut slots in your MonsterMill shield for setscrews?

I think I'd find it annoying to take out the setscrews just to get the hopper off to clean the mill. So I was thinking of using a Dremel to cut slots down to the bottom below the setscrews holes so I could remove it easily. Anyone else done that or is it a bad idea?


dcbw is offline
 
Reply With Quote
Old 02-16-2013, 06:58 PM   #2
Hammy71
Senior Member
HBT_SUPPORTER.png
 
Hammy71's Avatar
Recipes 
 
Join Date: Sep 2008
Location: , Maryland, The Tax Me State
Posts: 5,861
Liked 518 Times on 393 Posts
Likes Given: 806

Default

Should work, but I just use compressed air (I'm in my garage so no big deal there) to clean it.
Hammy71 is offline
 
Reply With Quote
Old 02-16-2013, 08:04 PM   #3
BrewBobaloo
Recipes 
 
Join Date: Feb 2013
Location: Booger County, AR
Posts: 2
Default

Looks like a bad idea to me. +1 compressed air. I don't wet mill, so I rarely need to take mine apart, just blow it out.
BrewBobaloo is offline
 
Reply With Quote
Reply

Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
What's the width of your monstermill? Fit hopper to Schmidling attempt. Infidel Other 6 11-21-2013 06:28 PM
MonsterMill thumbscrew tighness and gap adjustment dcbw Equipment/Sanitation 8 12-03-2012 10:05 PM
Slots or Holes Zuljin All Grain & Partial Mash Brewing 14 04-06-2012 12:24 AM
Mash tun slots silverbrewer Equipment/Sanitation 0 05-05-2009 05:43 PM


Forum Jump