Just got my PID/SSR combo from ebay: http://www.ebay.com/itm/280879156946...84.m1423.l2649
Might be me (probably) but I'm having trouble reading the Engrish translated instructions.
I searched, but it seams the PID diagrams I've found have a different pin-out than this one. Hoping somebody else knows this unit.
The thermo sensor is a PT100 (three-wire) which has two green, and a red wire.
Looking at the pin-out below, should I hook the two green wires to #12 and #13 and the red to #11? Does #10 and #11 need a jumper?
Do both "hot" leads of my 240vac go to #1 and #2?
I understand both legs of the 240vac should be switched before the element in the LT. Can I use a second SSR and power them both from the #7 and #8 signal? Thanks a bunch!