Noob notes-- a month in review - Home Brew Forums
Home Brew Forums > Home Brewing Beer > Beginners Beer Brewing Forum > Noob notes-- a month in review

Reply
 
Thread Tools
Old 01-21-2013, 03:36 AM   #1
beerluvva
Recipes 
 
Jan 2013
Posts: 94
Liked 4 Times on 3 Posts



Thought I'd pass on some experiences from my first month of home brewing...This post fueled by rum and cokes instead of home brews for reasons that will become obvious below...

Batch 1: Munton's Highland Heavy kit, Christmas gift from SWMBO along with plastic bucket kit. she's a keeper!

Sanitizer: clorox&water solution. Chose this mainly be because I could get started without a trip to my LHBS which is not all that local.

Method: followed kit instructions, since the LME was prehopped did not do a boil per se, boiled plain water then mixed all extract and water in fermenter. Of the 5 gal batch, 2 gallons were boiled, the remainder added cold from tap in the fermenter. Have a question about this at end of the post...

Insertion of airlock: reminded me of prom night. Shaking too much to hit The target. Pushed too hard, airlock grommet into the wort. Minor panic attack, but after sinking to the level of my training, improvised with a rubber band wrapped around The airlock stem. Not pretty but wedged it in there.

Cooling wort: comedy of errors, cue Benny Hill theme. Did not prepare any kind of ice bath , did not sufficient ice in house for said bath, being a noob i have no, and am slightly afraid of, wort chiller...ended up making space inside my chest freezer and putting fermenter in there until stickon themo. Indicated a temperature I could actually see, think around 78 deg.. F. "cold crash" took only 60 minutes.

O.g. Measurement: let's say 1.042. You'll have to trust me.

the windup, and the pitch: pitched the little dry yeast packet from the kit into the 78 deg. Wort. The kit made me do it.

Fermenter placement: in basement, on workbench next to lamp I am fixing for SWMBOs mom. Reflect upon photos of homebrew caves from this forum and feel simultaneously inadequate yet "keepin it real"

Religious monitoring of fermenter: no bubble activity for first 24 hours. Read , re-read, and transcribe Revvy's posts on fermenter activity for faith & guidance. Gave it the shake & swirl. And lo..bubbles.

Channel HBT zen: left fermenter alone, but noted temp. And airlock activity daily. Temp ended up stabilizing 64-66 deg. took gravity reading. Around 1.020. Tell myself I made a session beer, and feel proud that I'm above those just hazing big alcohol beers.

Bottling: purely on basis that fermentation "should be done" in a week, racked to bottling bucket,

Oh no, forgot priming sugar. In panic, grab ancient bottle of store bought simple syrup from fridge. Measure out correct amount by weight, and add to bottling bucket.

then Bottle using beer bottles, soda bottles, baby bottles, anything I can find, as I don't really realize how much beer 5 gallons is. While bottling, I make sure to avoid use of the bottling wand that came with my kit, and glug it straight into tHe bottles from the bucket spigot. Lots of foam and oxygen in the bottles.

Capping: no problems I can actually remember. However, after all is done I realize my finger is bleeding. No idea.

Bottle condition: after 1 week, I sneak a boTtle to see what a young beer tastes like. To my surprise it is not great, but drinkable. Can tell the low alcohol, ESP compared to my usual tastes, which run to the higher ABVs. I notice a slight sour note I the aroma and taste, but it is light.

In subsequent days, I sample more bottles, and it seems the souring is worse. Look up possible causes, and thinking it is some bacterial thing, likely acetobacter. (Palmer text)

And now, the question. I blame the souring on the following, in order of "worst sanitizing /process mistake"
1. Simple syrup primer
2. Churning / foaming while bottling
3. Poor use of Clorox sanitizer
3. Use of water direct from tap to make up the 5 gallons.
Any opinions?

undaunted, batch 2 is in fermenter now, actually my own simple extract based recipe. Stay tuned for noob notes #2. I've switched to star San for this batch, and did a partial boil, but still made up my final fermenter volume straight from tap.

I'm really loving the process and learning how to do all this, and really appreciate the forum.
Thanks
Beerluvva



2
People Like This 
Reply With Quote
Old 01-21-2013, 09:46 AM   #2
jethro55
Registered User
Recipes 
 
Dec 2012
Dayton, Ohio
Posts: 591
Liked 55 Times on 47 Posts


Great notes! I enjoyed reading it - all too familiar. Sounds like you are well on your way to mastering the hobby. From your post, persistence seems to be clearly on your side and that will pay off quickly.

Things got easier and patience was easier after I established a pipeline with two or three brews in various stages. I brew one every two or three weeks and then bottle or transfer on the other weeks.



 
Reply With Quote
Old 01-21-2013, 01:57 PM   #3
stevehardt
Recipes 
 
Dec 2011
lakewood ranch, florida
Posts: 450
Liked 45 Times on 37 Posts


Awesome notes. Getting better comes from learning from your mistakes.

Did I read correctly that you bottled afte a week?

 
Reply With Quote
Old 01-21-2013, 02:04 PM   #4
redman67
HBT_SUPPORTER.png
 
redman67's Avatar
Recipes 
 
Feb 2010
Taunton, MA
Posts: 428
Liked 22 Times on 19 Posts


Ive found that alot of this is preparation be prepared and it will go a lot smoother
__________________
Because God hates it when you drink bad beer

 
Reply With Quote
Old 01-21-2013, 02:13 PM   #5
grem135
Recipes 
 
May 2012
St. Louis, Mo.
Posts: 772
Liked 78 Times on 64 Posts


Nice notes, fun to read.
1st: Patience grasshopper. leave beer in fermenter for 3 weeks
2nd: foaming/splashing at bottling. Use bottle wand and check out Revvys bottling sticky.
3rd: you already fixed this... Starsan! Get spray bottle and wet everything that touches your beer after boil.
4th: check your water report. If they use cloromine then get campden tablets to treat water. Made huge difference for my beer.

5th and most important RDWHAHB
__________________
Brew On!

 
Reply With Quote
Old 01-21-2013, 09:19 PM   #6
beerluvva
Recipes 
 
Jan 2013
Posts: 94
Liked 4 Times on 3 Posts


Quote:
Originally Posted by stevehardt
Awesome notes. Getting better comes from learning from your mistakes.

Did I read correctly that you bottled afte a week?
It was about a week and a half...

Thanks to all for the encouragement & feedback, my 2nd batch is a week plus in, so i'll leave it go a few more.

In the meantime, queuing up ingredients for batch 3!

I think for guys like me, there should be RDGBACB (relax dude go buy a craft brew).

 
Reply With Quote
Old 01-22-2013, 03:29 AM   #7
OrdinaryAvgGuy
Recipes 
 
Jan 2013
Cary, NC - North Carolina
Posts: 998
Liked 181 Times on 128 Posts


Quote:
Originally Posted by beerluvva View Post
Insertion of airlock: reminded me of prom night.
LOL made me chuckle. I wasn't so lucky my prom night but I could imagine.
__________________
Primary:
Bottled:

 
Reply With Quote
Old 01-22-2013, 03:41 AM   #8
BeboThoughts
Recipes 
 
Oct 2011
Mississauga, Ontario
Posts: 10
Liked 1 Times on 1 Posts


Sounds like everyone here at some point or another!

I'd say to save one of those soured bottles and crack it in a year or so when you've got a lot more batches under your belt and your procedures a lot more *ahem* normalized. You'll be proud of yourself.

I still have a 3 bottles of my first homebrew. They're probably like a port wine that's been left in the sun by now. I'll crack them one day

 
Reply With Quote
Old 01-22-2013, 03:43 AM   #9
masterfool101
Recipes 
 
Dec 2012
San Francisco Bay Area, California
Posts: 272
Liked 19 Times on 16 Posts


Quote:
Originally Posted by grem135
Nice notes, fun to read.
1st: Patience grasshopper. leave beer in fermenter for 3 weeks
2nd: foaming/splashing at bottling. Use bottle wand and check out Revvys bottling sticky.
3rd: you already fixed this... Starsan! Get spray bottle and wet everything that touches your beer after boil.
4th: check your water report. If they use cloromine then get campden tablets to treat water. Made huge difference for my beer.

5th and most important RDWHAHB
^^ This.

And to answer your question, if indeed there was an infection, my guess would be the simple syrup. You're not likely to get an infection from tap water ... And the bleach may have been used improperly, but its a small chance.
__________________
Nothing Beats a Fool's Luck . . . and I am the Master Fool.

 
Reply With Quote
Old 01-23-2013, 02:44 AM   #10
beerluvva
Recipes 
 
Jan 2013
Posts: 94
Liked 4 Times on 3 Posts


Quote:
Originally Posted by BeboThoughts View Post
Sounds like everyone here at some point or another!

I'd say to save one of those soured bottles and crack it in a year or so when you've got a lot more batches under your belt and your procedures a lot more *ahem* normalized. You'll be proud of yourself.

I still have a 3 bottles of my first homebrew. They're probably like a port wine that's been left in the sun by now. I'll crack them one day
I did save one away...thought I'd keep one of every batch done this year, then at the end of the year, compare them and see how the long bottle conditioning affected them.



 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Brewing Notes batfishdog37 General Beer Discussion 23 04-26-2014 06:10 PM
Noob Recipe Review travelingbrewer357 Beginners Beer Brewing Forum 2 01-06-2013 12:23 AM
Take good notes! amh61 Beginners Beer Brewing Forum 6 12-20-2012 04:07 AM
Schneider Aventinus Weizenbock Beer Review - Beer Review Dude jbrookeiv Commercial Brew Discussion 2 04-15-2011 06:24 PM
2 meads 4 month review svengoat Mead Forum 3 08-23-2009 12:19 AM


Forum Jump