Reverse osmosis Holding Tank, Installed in Keezer / Kegerator with Facet on Lid - Home Brew Forums
Home Brew Forums > Home Brewing Beer > General Beer Discussion > Reverse osmosis Holding Tank, Installed in Keezer / Kegerator with Facet on Lid
Cool Brewing Corny 5G & Mini Giveaway

Reply
 
Thread Tools
Old 01-10-2013, 09:44 AM   #1
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


I just bought the Watts Premier EX RO under counter water filter. I got this for a number of reasons, but mainly so that I don't have to buy spring water any more when I brew. It comes with a 3 gallon water tank which takes about 4-6 hours to fill, which is the reason for the tank. The RO process takes a while to complete so building up a usable amount for water needs to be stored.

As I was brainstorming ideas, I thought about storing the tank INSIDE my Keezer, and mounting the Faucet for the RO system to the top of my Keezer lid, then I would have fresh COLD water for drinking right out of the keezer. It would dispense both liquid bread and the cleanest water at the same time!

I would also be able to get big tubs and pots underneath it since there would be no sink in the way.

My question is - has any one had an RO system storage tank, placed far away (about 21 feet of tubing in my case to go around the outside of the kitchen and then up into the back side of the Keezer and then down into the stoarge tank) from the RO filter itself? How does it perform? Is there enough pressure from the RO system to fill the storage tank?

How would you run the tubing? Is there a better or specific type of water tubing I should use that is more malleable? I live on a military base so I would have to get permission to trench the tube to the back of the room and then replace the plastic tile. Is there a way to pull up cheap plastic tiles without breaking them, jackhammer the floor, re cement the floor, and then put back down the original tile?

I think going through the wall is out of the question since I would have to drill through the studs to get it back there and anything other than a small patch is above my pay grade. I don't have a basement or attic. I have a bathroom accross the hallway but I would have to route the filtered water line outside to keep the install clean and in the process drill 4 holes, two outside and two inside.

I think I am just going to run it along the front of the dishwasher, stove and cabinets and then along the wall. I think I can tuck it under the alliances pretty well but running it along the wall is going to be hard in the sense that it will be seen very easily. Are there any good conduits that someone can recommend? I attached two photos so you can see what I'm working with.

Again, my primary reason for asking is if any one knows or has a similar setup that the RO system storage tank and faucet still works, with the tank and faucet being far (21 feet) away from the filter. Also to see if you guys come up with any better ideas. I don't mind having some tubing visible to people; this is base housing and they are tearing it down soon anyway.
Not that I don't take pride in where I live; but lets be real - At least I have a gated community!

Thanks for the help!


Click image for larger version

Name:	photo (1).jpg
Views:	861
Size:	40.1 KB
ID:	93361   Click image for larger version

Name:	photo.jpg
Views:	583
Size:	34.1 KB
ID:	93362  

 
Reply With Quote
Old 01-20-2013, 05:31 AM   #2
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


I got it installed!!!!! Ice cold water from the tank being in the keezer!!!


Click image for larger version

Name:	image.jpg
Views:	572
Size:	42.2 KB
ID:	95454  

 
Reply With Quote
Old 01-20-2013, 05:33 AM   #3
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


Picture of tube
Click image for larger version

Name:	image.jpg
Views:	504
Size:	39.7 KB
ID:	95455  

 
Reply With Quote
Old 01-20-2013, 05:34 AM   #4
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


Tank and tubing in keezer
Click image for larger version

Name:	image.jpg
Views:	755
Size:	63.6 KB
ID:	95456  

 
Reply With Quote
Old 01-20-2013, 05:35 AM   #5
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


Under counter install
Click image for larger version

Name:	image.jpg
Views:	607
Size:	45.3 KB
ID:	95457  

 
Reply With Quote
Old 01-20-2013, 05:38 AM   #6
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


You can barely see the tube. Only on the short side of the wall. I hid it through the front of the dishwasher and drilled through the wood that separates each appliance.

Here's a photo of in between the stove and dishwasher. You can't see it from the dishwasher because the tube is inside the front panel.

Reason: Grammar

 
Reply With Quote
Old 01-20-2013, 05:40 AM   #7
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


Tube again
Click image for larger version

Name:	image.jpg
Views:	475
Size:	32.9 KB
ID:	95458  

 
Reply With Quote
Old 06-23-2013, 05:07 PM   #8
NeoBrew
NeoBrew
HBT_SUPPORTER.png
Recipes 
 
Join Date: Feb 2013
Location: New Brighton, Minnesota
Posts: 375
Liked 60 Times on 50 Posts
Likes Given: 7


Looks like you got it figured out, I'm a little late to this thread. I have an RO system plumbed to my kitchen sink that is 50+ feet from the RO system. The system is in my utility room. I used the same kind of polyethylene tubing that you did. It's been installed for about 8 years now with no problem.

I can't imagine why anybody would not have an RO system to brew beer! Now...I have to envy your keezer. Perhaps it's time for a project...

buzzman003 Likes This 
Reply With Quote
Old 06-24-2013, 04:17 AM   #9
Hackwood
Recipes 
 
Join Date: Mar 2011
Location: Phoenix, Arizona
Posts: 645
Liked 63 Times on 53 Posts
Likes Given: 122


I wish I would have seen your post earlier. I do RO and soft water for a living. Looks like you got it done pretty nicely though. I have to ask, where is your RO spigot?
__________________
Fermenting - Nothing.
Lagering - Nothing.
Secondary - Nothing.
Bottle-aging -Nothing.
In the Fridge - Brian's Best Bitter
.

 
Reply With Quote
Old 06-24-2013, 11:58 PM   #10
buzzman003
Recipes 
 
Join Date: Aug 2012
Location: New Mexico, New Mexico
Posts: 47
Likes Given: 8


The spigot is on the sink in the corner. The reasons I didn't add it to the top or on the keezer were for two reasons. One, the faucet would be mounted to the top lid, which gives the advantage of instant ice cold water. The disadvantage, however is that I can't open the lid all the way like I can now. That's why I off set my taps so that I can lift a heavy keg over the wall with a fully open lid and no taps or lines in the way. The second reason is that there is no main drain, so I would have to empty a collector. Another nominal reason, was that I couldn't wash vegetables or rinse my dishes with the water (for spot free drying) without a full sink. Works really good! Super ice cold water in 20 seconds. Cold water in 10.


__________________
Secondary 2: Russian Imperial Stout, brewed 3 Oct, 2014 Draft Keg 1: Boulevard Brewing Tank 7 Draft Keg 2: Draft Keg 3: stout of some kind, I forgot Draft keg 4: Sparkling water at 55 psi - To brew: Hefeweizen, AG

 
Reply With Quote
Reply

Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Reverse Osmosis Water? Boyd Beginners Beer Brewing Forum 35 08-19-2010 03:04 PM
reverse osmosis sithspitt Equipment/Sanitation 38 09-14-2009 05:04 PM
Reverse Osmosis / DI Water Cytosol Beginners Beer Brewing Forum 3 07-08-2009 09:30 PM
Reverse Osmosis Water eschatz Recipes/Ingredients 17 07-11-2008 05:47 PM


Forum Jump