I purchased this DIY keggle set off of ebay, the seller said the top would be cut out and holes drilled appropriately AND the weldless fittings would be shipped with the keg.
The keg was delivered with everything promised, all was great until I saw where he drilled the holes.
I measured 3inches from bottom of keg. I tried putting the weldless fittings in place, they were the same as you would get from Bargain Fittings. Because the holes are so low, they run off down the rounded edge at the bottom of the keg. I can't quite seem to get things tight.
Also the other hole is drilled right ontop of the keg vent. I'm just confused and upset at this. I admit I overpaid for this because I wasn't patient enough to find a keg and drill the holes myself.
Anyone think this is redeemable?