Keg O Ring question - Home Brew Forums
Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > Keg O Ring question
Cool Brewing Giveaway - Supporting Membership Drive & Discount

Reply
 
Thread Tools
Old 01-06-2013, 03:15 AM   #1
jdboes
Recipes 
 
Aug 2012
Missoula, Montana
Posts: 22
Liked 7 Times on 5 Posts



Has anyone purchased o-rings from harbor freight to rebuild a keg? I was looking their earlier and noticed they have quite a variety to chose from. What type would be best to use? There are o-ring made of Nitrile, Viton, and HNBR available. Will any of these work? Thanks for the help.



 
Reply With Quote
Old 01-07-2013, 12:43 AM   #2
jdboes
Recipes 
 
Aug 2012
Missoula, Montana
Posts: 22
Liked 7 Times on 5 Posts


Bump



 
Reply With Quote
Old 01-07-2013, 12:46 AM   #3
jdub1782
HBT_SUPPORTER.png
Recipes 
 
Jan 2012
Aurora, IL
Posts: 108
Liked 7 Times on 7 Posts


Take a look at this thread, it is not specific to harbor freight, but it gives good info on the different types.

http://www.homebrewtalk.com/f11/mcma...g-list-233086/

 
Reply With Quote
Old 01-07-2013, 06:43 AM   #4
jdboes
Recipes 
 
Aug 2012
Missoula, Montana
Posts: 22
Liked 7 Times on 5 Posts


Thank! I'll check it out

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
O-ring question deflagratio Equipment/Sanitation 1 06-10-2012 05:06 PM
O-Ring question - used cornies? robertbartsch Equipment/Sanitation 13 08-19-2010 08:06 PM
Polysulfone QD O-ring question Buford Equipment/Sanitation 5 11-16-2009 06:05 PM
Should I replace this o-ring? And a serious question... nostalgia Bottling/Kegging 3 08-22-2008 10:34 PM
Little red rubber o-ring thingie question Seabee John Equipment/Sanitation 2 06-04-2008 04:04 AM


Forum Jump