Can someone pull some tri-clamp part measurements? - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > Can someone pull some tri-clamp part measurements?

Thread Tools
Old 11-23-2012, 10:52 PM   #1
Dec 2010
VA Beach, VA
Posts: 886
Liked 71 Times on 52 Posts

Hoping someone can help with the following so I can see if I can use off-the-shelf parts to build a manifold:

1) Width of the Brewer's Hardware 3-way 1" Tri-Clamp valve from flange-to-flange
2) Width of a 1" Tri-Clamp Tee also flange-to-flange

Thanks much,

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
tri-clamp (1 1/2 clamp width) rustybeer Electric Brewing 2 10-24-2012 02:05 PM
Part Yeast Part All-Grain Inquiry Tkelly32 Fermentation & Yeast 7 02-11-2012 11:53 PM
If you're not part of the solution, you're part of the precipitate bdub Mead Forum 5 10-28-2010 11:39 PM
Part Ale Part Lager Yeast? digdan Recipes/Ingredients 5 04-30-2009 09:27 PM
Recipes with part LME and part DME bobbo Recipes/Ingredients 5 05-25-2007 12:25 PM

Forum Jump