Install a ball valve into your boil kettle (it's not really a kettle until you have installed a ball valve in it, it's just a pot until then). Once you have the kettle setup, just drain into your fermenter(s) and you're good to go. Transfer time will be significantly faster than with a siphon. I think I used a siphon to transfer one of my partial boil batches (which would be one of my first three beers brewed). After that, I installed a ball valve and make the pot into a kettle.
With stainless steel you'll need either a good step bit, lube, way to keep what you're drilling (and the bit) cool, and a decent (low speed) drill. There are more than a few threads already posted about drilling through stainless steel to install a ball valve. Go read through them to find out how to best do it.
Hopping Tango Brewery
跟猴子比丟屎 ・ Gun HOE-tze bee DIO-se
On Tap: Caramel Ale, Mocha Porter II, MO SMaSH IPA
Waiting/Carbonating: 12.5% Wee Honey II, 8.9% Old Ale, English Brown Ale, Lickah ESB, Mocha Porter II
K2: Epic mead
On Deck: Caramel Ale
Mead [bottled]:Oaked Wildflower Traditional, Mocha Madness, Blackberry Melomel, maple wine