Where to find a v-belt pulley? - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > Where to find a v-belt pulley?

Reply
 
Thread Tools
Old 08-21-2007, 05:23 AM   #1
magno
 
magno's Avatar
Recipes 
 
Feb 2006
Austin, TX
Posts: 900
Liked 9 Times on 6 Posts



I jsut put together a stand for my grain mill. The only time that Ive use it so far, I had trouble keeping the RPMs down. When the grains were in the hopper, the drill either wanted to go full bore or not at all.

Here's the deal: my dad has an old lathe that hasnt been assembled, much less used, in years. The lathe has a 1/3 HP motor that I am daydreaming about mounting to the mill. The motor turns at 1750 RPM and has a V-belt pulley with a radius of 9/16 inches. I figure that I need a pulley of radius 5.5 inches or so to slow the RPMs down below 200 as is recomended.

CUT TO THE CHASE: Where can I get an 11 inch diameter V-belt pulley hopefully with a 3/8" bore?

Side question: What is the drawback to the mill turning faster than 200 RPM? My crush looked good, and didnt stick.

Thanks in advance.

- magno
__________________
Planning: New brewery at new house!!

Primary: Barley Wine

Secondary: Red Ale, Pale Ale

Conditioning:

Drinking: Brown Ale, 75 min. IPA, Oatmeal Stout, Poor Richard's Ale, Chocolate Cherry Stout

 
Reply With Quote
Old 08-21-2007, 07:35 AM   #2
AGBrewer
 
AGBrewer's Avatar
Recipes 
 
Feb 2007
Posts: 417
Liked 7 Times on 1 Posts


WWW.Mcmaster.com part #6245K931. 5.5 outside diameter, 1/2" bore, sorry best I could do

 
Reply With Quote
Old 08-21-2007, 11:17 AM   #3
evanmars
EAC Wannabe
HBT_LIFETIMESUPPORTER.png
 
evanmars's Avatar
Recipes 
 
Dec 2006
Springport, Michigan
Posts: 926
Liked 58 Times on 38 Posts


Local hardware or farm supply store.
__________________
Consistency is only a virtue if you're not a screwup

Primary - Duck Lake EPA
Duck Pee (Cream of Three Crops variant)

Secondary - 0
Kegged - 0 No kegs anymore :(
Bottled - 0

 
Reply With Quote
Old 08-21-2007, 01:34 PM   #4
david_42
 
david_42's Avatar
Recipes 
 
Oct 2005
Willamina & Oak Grove, Oregon, USA
Posts: 25,593
Liked 151 Times on 142 Posts


Brisa evaporative cooler blower pulley #5-3-59 (1-800-325-6952) Might be a little bigger than you need.
__________________
Remember one unassailable statistic, as explained by the late, great George Carlin: "Just think of how stupid the average person is, and then realize half of them are even stupider!"

"I would like to die on Mars, just not on impact." Elon Musk

 
Reply With Quote
Old 08-21-2007, 02:19 PM   #5
Craig5_12
Recipes 
 
Jan 2007
Valley Springs, CA
Posts: 290

How about an old domestic pick n pull? Not sure what car/truck to aim you at but any pulley on a 70's back vehicle should be a v-belt.

 
Reply With Quote
Old 08-24-2007, 01:04 AM   #6
D*Bo
Recipes 
 
May 2006
North Attleboro, MA
Posts: 457
Liked 1 Times on 1 Posts


Tractor Supply
http://www.mytscstore.com/
__________________
PrimaryBaltica 9
Secondary British all Amarillo IPA, Calypso
Conditioning Decoction maddness, FlyingJess Ale
Drinking Oatmeal Chocolate Stout, Oaked Bourbon Chocolate Stout, Dry Mead)
Up NextScottish ale and Dopple Bock

Always ready for the wack snack attack, I carry sandwiches around in a straight edge style JanSports backpack.

Support your local businesses

 
Reply With Quote
Old 08-24-2007, 02:44 AM   #7
magno
 
magno's Avatar
Recipes 
 
Feb 2006
Austin, TX
Posts: 900
Liked 9 Times on 6 Posts


Thanks for the input. This project will probably be put on the back burner, but now I know where to look when Im ready.
__________________
Planning: New brewery at new house!!

Primary: Barley Wine

Secondary: Red Ale, Pale Ale

Conditioning:

Drinking: Brown Ale, 75 min. IPA, Oatmeal Stout, Poor Richard's Ale, Chocolate Cherry Stout

 
Reply With Quote


Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Brew Belt colin_rudolph Equipment/Sanitation 3 09-27-2010 10:08 PM
First AG under my belt! Lucky Dog Brewing All Grain & Partial Mash Brewing 6 04-22-2008 03:40 PM
First AG Under the Belt jacksonbrown All Grain & Partial Mash Brewing 6 04-07-2008 03:46 PM
Batch #1 under my belt! davidr2340 Beginners Beer Brewing Forum 23 03-12-2007 12:44 AM
Brew belt? dansmith13 Equipment/Sanitation 5 10-31-2006 01:16 AM


Forum Jump