Danby DAR440 and Johnson control a419abg-3c probe - Home Brew Forums
Home Brew Forums > Home Brewing Beer > Bottling/Kegging > Danby DAR440 and Johnson control a419abg-3c probe

Reply
 
Thread Tools
Old 11-09-2012, 06:20 PM   #1
laserghost
Recipes 
 
Feb 2012
Austin, Texas
Posts: 258
Liked 18 Times on 12 Posts



Just getting into kegging and converted a Danby DAR440w into a two tap system. So far, I've been having trouble getting the temperature right – it's either a little too warm or freezing.

I'd like to go ahead and get the Johnson controller (pre-wired) A419ABG-3C to hold the temp steady, but I'm wondering about how to get the probe inside the fridge cleanly.

Did some searching around but couldn't find an answer, anyone know a link or solution?

In these photos the lead and probe look kind of thick, and I'm not sure if it'll snake in through the drain outlet or not (I'm at work right now).

Would I have to drill a new hole for the probe and then seal it up? Anyone done this?

Thanks!



Reason: misspelling

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Danby DAR440 Door Panel is glued in place beerguy2009 Kegerators & Keezers 16 04-22-2013 12:24 AM
Great Deal on Johnson Controls Digital Thermostat A419ABG-3C $66 ultravista Equipment/Sanitation 5 04-30-2011 06:08 PM
Help with the Johnson Controls A419ABG-3C joenyc Equipment/Sanitation 3 03-05-2010 03:08 PM
Is a Johnson Thermostat Control probe waterproof? zimman Equipment/Sanitation 3 01-22-2010 11:52 PM
Johnson Temp Control Probe=waterproof? slim chillingsworth Equipment/Sanitation 7 07-10-2008 09:38 AM


Forum Jump