I am in the process of setting up a DX1 system for my direct fire RIMs system.
I have solenoids for the HLT and MLT. I have things wired up as follows:
HLT - OUT 1 to Relay 3
MLT - OUT 2 to Relay 1
When I run a program it starts out fine. I have it set to heat strike in the HLT. When I get to Dough in it is messed up. I would expect HLT relay to be off, and MLT relay to be on. But HLT stays on.
When I get to Sacch step, the relay of HLT does this double trigger.
I have checked everything and cannot figure out why it is not firing the relay for my MLT.
Please see the video: