Faucet Handles attempt - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Bottling/Kegging > Faucet Handles attempt

Thread Tools
Old 08-30-2012, 11:26 PM   #1
Mar 2012
Shreveport, la
Posts: 94
Liked 5 Times on 4 Posts

Well, I'm off to build these things. Havent' stained the first 'test' one yet. I figure after they are stained I"ll put one of those clear baseball card pouches on the front square and print out what each beer is when I keg it.

-- I did not come up with this, read about it on the net

Building was a LOT easier than I thought. By the parts in the pic (and a small wood dowell pin not shown). Use a pair of plyers to unscrew the post in the leg. Drill out the hole a bit. Tap the metal screw thingy in (it matched the threads a tad loose but more than tight enough to be solid). Drill small hole on top. Insert dowell. Drill small hole in the wood square. Tighten the leg unto the faucet tap screw. Put the square wood on the dowell (this makes it possible to line it up straight when the tap is on tight). Now time to stain and do 6 more.

ratsathome Likes This 
Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Is there an adapter to attach metric thread tap handles to a U.S. thread faucet? wipff Bottling/Kegging 4 01-19-2012 04:33 PM
Converting Keg Kit Faucet to Fridge Faucet... MellowToad Bottling/Kegging 1 02-13-2010 05:06 AM
where to find faucet handles? amishland Bottling/Kegging 5 06-08-2008 08:06 PM
Creamer faucet (not beer engine or stout faucet) david_42 Bottling/Kegging 8 02-05-2008 04:58 PM
Faucet Handles Loose Khirsah17 Bottling/Kegging 6 01-28-2008 07:34 PM

Forum Jump