Single tier HERMS - Home Brew Forums
Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > Single tier HERMS

Reply
 
Thread Tools
Old 07-04-2012, 02:39 AM   #1
rmaloney86
Recipes 
 
Jun 2012
Milford, Delaware
Posts: 98
Liked 8 Times on 7 Posts



I'm starting on my Single tier sculpture tomorrow and I have no worries concerning that portion of the build however I'm worried looking ahead to putting in temperature controlled burners, there are so many options and ways to do it, could someone point me in the right direction if I decide to use a Ranco controller? What do I need from there? I like how the Brutus 10 burners are set up but I do understand they are potentially unsafe



 
Reply With Quote
Old 07-04-2012, 06:39 PM   #2
OneHoppyGuy
Recipes 
 
Nov 2009
Concord, CA
Posts: 1,666
Liked 44 Times on 36 Posts


Use a PID and not the Ranco. A simple furnace gas valve, thermocoupler and standing pilot work fine. We use a more expensive method but it is the safest and easiest to install. We use a 'smart' gas valve with a hot surface pilot. Built in safety. Also, do not run gas through the frame if you are at all concerned about personal safety. Use black pipe rated for gas.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Single Tier HERMS build drkwoods Kegerators & Keezers 162 12-12-2014 07:01 PM
Single Tier HERMS System Build twstandley Brew Stands 0 02-09-2012 05:13 PM
Pumps for Single Tier Herms _d_ Brew Stands 5 09-30-2011 04:28 PM
Single tier HERMS with tri clovers all around Sarrsipius Brew Stands 10 12-20-2010 12:51 AM
Single tier HERMS reveal. SSRider Brew Stands 17 01-24-2009 04:34 AM


Forum Jump