I am in the works of building a new brew system/stand. I am going the low pressure route with Honeywell VR8200's for BK, MT & HLT. I am planning on having a common low pressure header and then splitting off for the 3 burners w/ individual isolation valves, VR8200's, flex hose and orifice/control valve.
The drawing I attached is similar but slightly different than what I am thinking now:
To feed the header, I was thinking about using this:
Has anybody had experience with it? Will it supply enough gas for 2 burners at once? Anybody know the BTU rating on it?
Do you think this is a good route to go or should I use a standard high pressure regulator and feed that to a Marshall 299-00?
Opionions on the matter would be much appreciated.