So after some thought and some digging here is my planned setup. I want to be able to later down the line to be able to switch to electric if I can (house dependent) without it being too painful, and also be able to run on NG or Propane if I buy the proper regulator.
2x BG-14 Burners @ $32.49 each Link
2x Natural Gas Valve Orifice @ $7.00 each Link
2x Honeywell VR8200A2132 Standing Pilot Valve @ $60 each Link
2x Honeywell Q390A1046 24" Thermocouple @ $3.50 each Link
2x Honeywell Q314A4586 Pilot Burner @ $17.75 each Link
1x Honeywell AT175A1008 24v 75VA @ $27.95 each Link
2x Auber SYL-2362 @ $42.55 each Link
2x Auber Platinum RTD. PT100 (6 ft. cable) @ $15.65 each Link
1x Auber ASL-51 @ $34.50 each Link
The only switches I plan on having are for my 2 pumps, control panel power, EPO, a on/off for the BK, and a MOA for the HLT.
My thought on these RTD's is that I could easily slide them into thermowells that I have in all 3 vessels to display temp and control the HLT for my HERMS setup.
I think most people go with the screw in type, does anybody have experience with these?
Any input/help would be greatly appreciated.