GRRRRRRRR So I got my "used like new" Greenlee hole punch from Amazon and the friggin threads are all
****ed up on it! the cutting part will only screw on about a 1/4" before stopping and no amount of force I can exert will make it go any farther.
So I saved $15 bux instead of buying a new one by getting the used one, lesson learned I guess. I managed to seperate the washer/bearing assembly from the main shaft. I am going to head into to town and see if I can find a grade 8 bolt to replace the one with messed up threads and get this to work. I don't want to spend the time waiting for a refund and a replacement since Amazon free shipping is sllllooowww took over a week for this to get here as is.
I will post back later whether I am successful.
Also I am building this jig today:
With the Greenlee pass around I will include the keg cutting jig that way folks can cut the tops off and make their bulkhead holes all at once. Seems silly for us all to buy the stuff.
Hell after I polish my kegs I will include the grinder and backing wheel etc. Since once I have polished my kegs, cut the top off and put the holes in them all this stuff would sit in a closet collecting dust and I would never use it again. I'd rather see it go to people to help them with their rigs then just sitting not being used.