Temperature Sensors Location - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Electric Brewing > Temperature Sensors Location

Reply
 
Thread Tools
Old 01-30-2012, 04:23 PM   #1
bgarino
Recipes 
 
May 2010
florida
Posts: 98


I a starting my E_HERMS build and want to know where everyone is placing the temp sensors from the PIDs. What's better in the keggle or T off the valves? Any help and pics would be greatly appreciated..

Brett

 
Reply With Quote
Old 01-30-2012, 04:30 PM   #2
iijakii
 
iijakii's Avatar
Recipes 
 
Jun 2010
Portland-ish, OR
Posts: 6,004
Liked 1791 Times on 1120 Posts


A lot of people T off of the valves, I'm going to be using a T from my sightglass. Or you could always put the probe by itself. That's just another hole to drill though...

 
Reply With Quote
Old 01-30-2012, 05:49 PM   #3
mabrungard
HBT_LIFETIMESUPPORTER.png
 
mabrungard's Avatar
Recipes 
 
Feb 2011
Carmel, IN
Posts: 4,116
Liked 598 Times on 463 Posts


You want the sensor as close as possible to your heat source in either HERMS or RIMS. That improves the reliability and response of your heating controls.
__________________
Martin B
Carmel, IN
BJCP National
Foam Blowers of Indiana (FBI)

Brewing Water Information at:
https://sites.google.com/site/brunwater/

Like Bru'n Water on Facebook for occasional discussions on brewing water and Bru'n Water
https://www.facebook.com/pages/Brun-...?ref=bookmarks

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tri clover RTD temp sensors bowhuntah Electric Brewing 4 11-15-2011 03:07 AM
Whirlpool valve location with a heating element wedge421 Electric Brewing 2 10-22-2011 07:14 PM
Location for pickup/valve & element ceejengine Electric Brewing 2 08-29-2011 06:50 PM
PID and I2C Temperature Sensor? TriangleIL Electric Brewing 17 02-22-2011 09:49 PM
temperature sensor to 10 bit ADC cheese Electric Brewing 10 12-14-2010 07:55 PM


Forum Jump