Spike Brewing Giveaway - New v3 Kettle

Home Brew Forums > Home Brewing Beer > DIY Projects > Kegerators and Keezers > Kegerator tower cooling: Single to Dual facet
Thread Tools
Old 01-22-2012, 10:55 PM   #1
Feedback Score: 0 reviews
Join Date: Dec 2011
Location: Palm Beach Gardens, FL
Posts: 2
Default Kegerator tower cooling: Single to Dual facet

Hey guys.
Wonding about tower cooling going from a single tower to larger dual tower. The current kegerator pass-through hole is 1 and 5/8 inch diameter. The dual faucet Micromatic tower I want to add is 3 inch diameter. Concern is the opening size and if it will be adquate to keep the 3 inch tower and beer lines cold enough to perserve the beer properly. The two lines will fit through the hole but there will not be much excess space. There currently is no fan inside the kegerator. It will be a pain to widen the hole.

Anyone upgraded a tower like this?
Did the smaller hole opening workout okay?


LizardLounge is offline
Reply With Quote
Old 01-23-2012, 03:54 AM   #2
Feedback Score: 0 reviews
Join Date: Jun 2011
Location: spring, tx
Posts: 87

I'd wire up a pc fan. Put it in a $3 electric box from home depot and run a 3/8 in vinyl hose into the tower.

If the tower is place away from the fridge you can wrap the beer lines and vinyl hose in insulation. It will help keep the lounges cool. It doesn't take much air flow to cool the tower
postalbunny is offline
Reply With Quote
Old 01-23-2012, 04:28 AM   #3
Feedback Score: 2 reviews
purplehaze's Avatar
Join Date: Mar 2011
Location: , Massachusetts
Posts: 384
Liked 22 Times on 22 Posts
Likes Given: 9

Default tower cooling

There are a few threads with this very topic here. If you don't want to go the fan route, make the hole bigger and install two 1/2 inch copper pipes. The pipes will extend into the fridge a couple of inches and go up the tower to just below the shanks. Then fill the tower around the copper with expanding foam. The copper will pull the cold all the way up the tower. Your beer lines will travel inside the copper to the shanks keeping the beer lines cold. Cheap and simple.
purplehaze is offline
Reply With Quote

Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Kegerator Tower-Copper pipes vs. Cooling Fan bkaqm6 Kegerators and Keezers 7 11-15-2015 05:15 PM
Converting a Single Tower to a Dual Tower?!? nunzio42 Kegerators and Keezers 5 09-12-2013 05:43 AM
kegerator tower cooling power supply discoross Kegerators and Keezers 11 07-29-2011 11:22 PM
Kegerator tower cooling kshuler Kegerators and Keezers 16 04-03-2011 06:35 AM
Cooling Tower in HomeMade Kegerator magoo0903 Kegerators and Keezers 1 08-17-2010 03:55 AM

Forum Jump