dwh7016c - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Fermenters > dwh7016c

Reply
 
Thread Tools
Old 01-17-2012, 08:55 PM   #1
deaconfrost28
Recipes 
 
Jan 2012
North Canton, OH
Posts: 1


DWH7016c-This is the controller i have bought. I wired it up as the diagram said using an extension cord splicing and the controller does not work correctly. If i set it to 0c nothing happens... if i set it to say 30c the compressor kicks on but this is backwards from what SHOULD happen. anyone know what i need to do.

 
Reply With Quote
Old 03-29-2012, 10:55 PM   #2
Sapperaviator
Recipes 
 
Mar 2012
Clarksville, Tn
Posts: 16


I just got mine in the mail, i am trying to figure out how to wire, (electricity is not my forte). I will let you know if I have the same issue.

 
Reply With Quote
Old 03-29-2012, 10:58 PM   #3
OneHoppyGuy
Recipes 
 
Nov 2009
Concord, CA
Posts: 1,666
Liked 44 Times on 36 Posts


I looked at the wiring, it is designed to be wired only one way, so the problem is more than likely not wiring. I would read through the programming instructions and make sure you have it turning on and off in the right manner.

 
Reply With Quote
Old 03-30-2012, 03:27 PM   #4
Sapperaviator
Recipes 
 
Mar 2012
Clarksville, Tn
Posts: 16


I got this from the other discussion. The thermostat is set to heat not cool.
H
1. Hold down set button for 3 seconds.
2. When HC appears press set button again.
3. It will most likely show H for heat. Press down arrow, should now show C for cold.

 
Reply With Quote
Old 03-30-2012, 03:40 PM   #5
Sapperaviator
Recipes 
 
Mar 2012
Clarksville, Tn
Posts: 16


This is the diagram I used to wire mine, which is different than what was sent with the product.
Click image for larger version

Name:	user45275_pic5712_1322846032.jpg
Views:	940
Size:	44.8 KB
ID:	54846  

 
Reply With Quote
Old 11-16-2016, 01:13 PM   #6
jecwow
Recipes 
 
Nov 2016
Posts: 1

I bought one of these too and used the above wiring diagram since theirs was confusing. It wouldn't come on so I switched wires 1 & 2, (which matched the diagram that came with it), then my keezer came on. You have to make sure it is in "Cooling" mode. Reads in Celsius only and will not switch to Fahrenheit. The instruction sheet that came with it is good for programming but little else. If you buy one and start to wire it up, leave long leads.

 
Reply With Quote
Reply
Thread Tools



Forum Jump