Johnson A350aa-1 wired but not working - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > DIY Projects > Johnson A350aa-1 wired but not working

Reply
 
Thread Tools
Old 01-13-2012, 02:57 PM   #1
ScottD13
Recipes 
 
Aug 2005
Jersey
Posts: 303
Liked 1 Times on 1 Posts



Anyone have a Johnson A350aa-1 controller or A350A/B contorller?

I wired my up according to the specs and it's not working. I have double checked that all the wiring in the plug and socket are right, when not attached to the controller it's fine.

It could be bad unit but I'm not sure what it meant in the diagram that in the example it's wired to an External 10 VA Transformer. Does that mean I shouldn't wire it direly with a plug, ie a need a 10 volt transformer?

Thanks!
__________________
NJHOPZ

 
Reply With Quote
Old 01-13-2012, 04:37 PM   #2
day_trippr
Recipes 
 
May 2011
Stow, MA
Posts: 17,155
Liked 2924 Times on 2183 Posts


"It's dead, Jim".

According to the product manual, that single stage controller runs on 24VAC, and switches a single relay. While the relay can switch 110VAC for use with a heating or cooling unit, the controller logic will likely be well toasted if run on 110VAC...

 
Reply With Quote
Old 01-13-2012, 04:47 PM   #3
ScottD13
Recipes 
 
Aug 2005
Jersey
Posts: 303
Liked 1 Times on 1 Posts


dam
__________________
NJHOPZ

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Blue Brew Bench Phase II - Wired Cpt_Kirks Brew Stands 7 01-03-2011 07:13 PM
Ranco vs. Johnson wolfe006 Brew Stands 7 12-02-2009 10:51 PM
Is my PID working??? gtg644w Brew Stands 2 10-22-2008 03:20 AM
Why would you buy a ranco pre-wired RockfordWhite Brew Stands 11 09-03-2008 10:31 PM


Forum Jump