RTD pinout - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Electric Brewing > RTD pinout

Reply
 
Thread Tools
Old 01-08-2012, 06:18 PM   #1
bowhuntah
Registered User
Recipes 
 
Jun 2011
Windham, Maine
Posts: 111
Liked 2 Times on 1 Posts



I have a RTD sensor with panel mount quick disconnects from Auber. The sensor end came pre-soldered with pin 1=red, pin 2=white and pin 3=red. is this correct?

 
Reply With Quote
Old 01-08-2012, 08:57 PM   #2
Lucky_Chicken
 
Lucky_Chicken's Avatar
Recipes 
 
Jul 2011
Bloomfield, IA
Posts: 795
Liked 37 Times on 27 Posts


as long as your other side is wired the same I dont see a problem

 
Reply With Quote
Old 01-08-2012, 09:40 PM   #3
bowhuntah
Registered User
Recipes 
 
Jun 2011
Windham, Maine
Posts: 111
Liked 2 Times on 1 Posts


What I'm trying to confirm is that pin #2 at the RTD goes to terminal #5 at the PID (2352).

 
Reply With Quote
Old 01-08-2012, 11:33 PM   #4
P-J
HBT_LIFETIMESUPPORTER.png
Recipes 
 
Mar 2010
Charlotte, NC
Posts: 3,336
Liked 302 Times on 235 Posts


The red wires go to pins 3 and 4. The white wire goes to pin 5.


 
Reply With Quote
Old 01-09-2012, 08:12 PM   #5
audger
Recipes 
 
Apr 2011
., Connecticut
Posts: 1,497
Liked 43 Times on 42 Posts


^^correct.

btw the two red leads are connected together. some controllers compute the resistance of the lead wires in order to make the RTD calculations more accurate. if you measure the resistance between the two red leads, this is the number you subtract from the resistance measured between red+white leads to get an accurate reading.

 
Reply With Quote
Reply
Thread Tools



Forum Jump