burners - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > burners

Reply
 
Thread Tools
Old 12-31-2011, 01:51 AM   #1
taintedplay
Recipes 
 
Mar 2010
dallas
Posts: 112
Liked 1 Times on 1 Posts



im wanting to make a single tier (actually just starting with a stand to put burners on to start off with)

I want to have two burners that can put enough heat out to heat up 2d0 gallons of water (if i ever want to do a 15 gal batch) but will mostly do 15gal boils.

im building a stand out of 2x2 steel tubing I have from a past project.

what burners and regulators would be good to use?

 
Reply With Quote
Old 12-31-2011, 07:41 AM   #2
taintedplay
Recipes 
 
Mar 2010
dallas
Posts: 112
Liked 1 Times on 1 Posts


Also is there a general set of dimensions most people use for these?

 
Reply With Quote
Old 12-31-2011, 12:45 PM   #3
RoadKing
 
RoadKing's Avatar
Recipes 
 
Oct 2005
Bayville, N.J.
Posts: 467
Liked 22 Times on 19 Posts


I went with theese BG-14 HIGH PRESSURE CAST IRON BURNER - Agri Supply I can't help with regulaters 'cause I use them with natural gas.
As for dimensions, you need to figure out what suits your needs best.
Mine is 15.5'' X 60'' (there's a pic of it if you ckick my name.)
Good luck!
__________________
DIRTY GARAGE BREWING CO.

 
Reply With Quote
Old 01-01-2012, 02:48 AM   #4
davefleck
Recipes 
 
Oct 2007
Edgewater CO
Posts: 627
Liked 26 Times on 20 Posts


Quote:
Originally Posted by RoadKing
I went with theese BG-14 HIGH PRESSURE CAST IRON BURNER - Agri Supply I can't help with regulaters 'cause I use them with natural gas.
As for dimensions, you need to figure out what suits your needs best.
Mine is 15.5'' X 60'' (there's a pic of it if you ckick my name.)
Good luck!
Agri supply has the 0-30psi regulater that works on these. Haven't used mine yet but have test fired.

I think the mount holed are 10" apart

 
Reply With Quote
Old 01-01-2012, 02:56 AM   #5
OneHoppyGuy
Recipes 
 
Nov 2009
Concord, CA
Posts: 1,666
Liked 44 Times on 36 Posts


The mounting holes are 11.25 inches apart. Drill the holes oversized (3/8") and use large washer due to the poor castings.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
About to buy 3 bg-14 burners, anyone say no? nspaldi0 Brew Stands 19 03-21-2012 08:27 PM
Burners? HopDiggity Brew Stands 2 07-31-2011 09:59 PM
10 tip NG burners? Phunhog Kegerators & Keezers 2 07-13-2011 05:09 PM
Ten tip burners agezzi Brew Stands 0 06-01-2011 10:14 AM
burners hooks Brew Stands 3 03-19-2009 12:01 PM


Forum Jump