Knockout Punch sharing - Page 2 - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Knockout Punch sharing

Reply
 
Thread Tools
Old 11-27-2011, 01:49 PM   #11
emjay
 
emjay's Avatar
Recipes 
 
Jan 2011
Toronto, Ontario
Posts: 12,792
Liked 1719 Times on 1606 Posts


I bought the 13/16" Greenlee punch. It's used for 1/2" fittings, so I know I'll get a fair amount of use out of it. And we don't have Harbor Freight in Canada, so that wasn't an option.

After I'm done with it, it's high-quality and durable enough that I should be able to sell it (if I want to) at not *too much* of a loss, especially since the buyer should know he'll be able to do the same and that there is no lack of people needing this particular punch.

 
Reply With Quote
Old 11-27-2011, 02:10 PM   #12
jtkratzer
Senior Member
HBT_LIFETIMESUPPORTER.png
 
jtkratzer's Avatar
Recipes 
 
Oct 2010
Lititz, Pennsylvania
Posts: 2,811
Liked 39 Times on 39 Posts


Quote:
Originally Posted by emjay View Post
I bought the 13/16" Greenlee punch. It's used for 1/2" fittings, so I know I'll get a fair amount of use out of it. And we don't have Harbor Freight in Canada, so that wasn't an option.

After I'm done with it, it's high-quality and durable enough that I should be able to sell it (if I want to) at not *too much* of a loss, especially since the buyer should know he'll be able to do the same and that there is no lack of people needing this particular punch.
I need to get my hands on a set of calipers to get exact measurements of the fittings. I have 1/4" half couplings, 1/2" couplings, and 1.5" tri-clover ferrules to weld into the kegs...then there's all the stuff that goes into the control box.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Greenlee Hydraulic Punch is DaBomb! vballdrummer Kettles, Mash Tuns & Hot Liquor Tanks 2 04-11-2011 02:48 PM
chassis punch keggle? buffalobrewer Kettles, Mash Tuns & Hot Liquor Tanks 6 12-07-2009 03:32 AM


Forum Jump