I just finished building my brew system. I am running a VR8200 using LP with a constant pilot light on an Auber SYL-2362 PID. I just completed my first test run.
Here is the problem: When my water temp in my HLT reaches ~80F, the PID shuts the gas to the burner off. If I pull the RTD out of the thermo-well and the temp drops below 80F, the burner turns back on. It is very strange. I have the PID set to 165F.
Has anyone experienced this problem before.
BTW- I have another PID configured to run a HEX and it works flawlessly.