Problems with stouts and porters - Home Brew Forums
Home Brew Forums > Home Brewing Beer > Extract Brewing > Problems with stouts and porters

Reply
 
Thread Tools
Old 04-04-2007, 05:26 PM   #1
GregKelley
Recipes 
 
Feb 2006
North Royalton, OH
Posts: 165
Liked 7 Times on 6 Posts



Sorry for the cross-post for those of you who have seen this....

I'm an extract brewer using special grains.

I've been revisiting my brews over the last couple of years and have hit upon something. I've made brown ales, red ales, scotch ales, pale ales and various Belgians. They've all come out tasty with compliments from picky friends.

However, when I attempt to make a stout or a porter they typically come out bland and sometimes maybe too bitter.

I downloaded a podcast on pH and its affects on taste and plan to listen intently. But I'm wondering, is there something common to how stouts and porters are made vs. the other types that could be the key to my mistakes. Thoughts I've had are:

1. water hardness - do stouts and porters require something different from the other beers mentioned?
2. malt and specialty grain types - am I screwing something up in steeping
3. inherent difference in taste profiles - maybe stouts and porters, or atleast the ones I make, are inherently less tasty and a little more bitter.

Just looking for thoughts from the experts. Thanks!



 
Reply With Quote
Old 04-04-2007, 05:36 PM   #2
mmmforbiddendonut
Recipes 
 
Feb 2007
Columbus, OH
Posts: 36

1. Hardness should have little effect on an extract brew even with specialty grains. It's usually a worry for the partial mash/all grain people.
2. As long as you are following general instructions i.e. steeping 30 minutes at around 160F, have the grain milled etc. you should be fine. By way of extract, be aware that extracts such as Amber and Dark already contain crystal malt and in the case of dark usually has a chocolate or black patent (or a combination.) I learned this the hard way.
3. Both styles are more bitter. I'm guessing by tasty you are referring to hops aroma and fruityness rather than merely good flavor. Use the recipator http://www.hbd.org/recipator/ to figure out recipes that are more to your liking. The recipator has all of the styles from the BJCP built into it and can give you an idea of what kind of hops utilization you are getting to balance out the bitterness and maltiness of the beer. Also consider the style of the stout or porter you are making. Some are inherently more bitter than others.

Although, don't take my word for it, I'm just a noob who reads a lot. Hope this helps.


__________________
- mmm forbidden donut

Primary: Empty! Ohno!
Secondary: #4 ESB
Waiting on Bottles: Nothing!
Drinking: #2 Woopsy Makes Everything All Right Sweet Stout, #3 Hefeweizen
On Deck: #5 NB 1554 Clone, #6 American Style Wheat

 
Reply With Quote
Old 04-04-2007, 05:59 PM   #3
TheJadedDog
AFK ATM
HBT_LIFETIMESUPPORTER.png
 
TheJadedDog's Avatar
Recipes 
 
Aug 2006
People's Republic of Cambridge
Posts: 3,316
Liked 16 Times on 13 Posts


I'm not an expert by any means, but are you using enough malt? Both the styles you mention typically have higher OGs and are characterized more by their malt profiles than hops. While stouts should be drier and more bitter than porters, neither style should have a lot of hop flavor or aroma.

It might be helpful to see your recipes to truely diagnose the problems.
__________________
And now we go AG!

On Tap: Nadda
Primary: Nadda
Planning: Extra Special Bitter

 
Reply With Quote
Old 04-04-2007, 06:03 PM   #4
david_42
 
david_42's Avatar
Recipes 
 
Oct 2005
Willamina & Oak Grove, Oregon, USA
Posts: 25,593
Liked 151 Times on 142 Posts


Water doesn't matter much for steeping.

It can be tough to get the maltiness necessary with extract. You might try a Maris Otter-based extract.

Look for commercial porters/stouts you like, then find a clone recipe. I worked on my own porter recipe for years, found one for Rogue Mocha Porter and tossed mine. It has three times as much Caramel as mine did.
__________________
Remember one unassailable statistic, as explained by the late, great George Carlin: "Just think of how stupid the average person is, and then realize half of them are even stupider!"

"I would like to die on Mars, just not on impact." Elon Musk

 
Reply With Quote
Old 04-04-2007, 06:06 PM   #5
FlyGuy
 
FlyGuy's Avatar
Recipes 
 
Jan 2007
Calgary, Alberta
Posts: 3,605
Liked 178 Times on 51 Posts


Also, are you steeping or partial mashing? By your description of the thin-ness and bitterness of your brews, I am wondering if you only steep. I found that when I started partial mashing, my brews were more well-rounded with more body, even after adjusting recipes for the higher extractions you get with a PM over steeping grains.

 
Reply With Quote
Old 04-04-2007, 06:23 PM   #6
GregKelley
Recipes 
 
Feb 2006
North Royalton, OH
Posts: 165
Liked 7 Times on 6 Posts


I am steeping, not mashing. However, my last brew called for flaked barley and I only steeped it. I found out afterwards I should've partial mashed. Haven't done that yet, but I will be trying soon.

To answer the other questions....
I do love stouts and porters and know that they are bitter. Mine just seem to have less body. I have tried 2 clones of beers that I like and both didn't turn out so hot.

To be honest, almost everyone one of my beers has some little "mistake" that I realize hours later and kick myself for making it. It just seems that with my stouts and porters the mistake had a more negative impact that with my browns, belgians, pale ales, etc.

 
Reply With Quote
Old 04-04-2007, 06:41 PM   #7
Dude
Will work for beer
HBT_LIFETIMESUPPORTER.png
 
Dude's Avatar
Recipes 
 
Jan 2005
Knob Noster, Missouri
Posts: 8,770
Liked 87 Times on 70 Posts


Are you using too much black patent? Black patent can be really bitter--almost astringent.

I also think the hard water has more to do with it than people here are saying. I had the exact same problem when I brewed an extract stout.
__________________
On Tap: Lake Walk Pale Ale -- Eternity (Raspberry Stout) -- Nutrocker -- Donnybrook Dark
Primary: Lake Walk Pale Ale
Secondary: Summit IPA
Up Next: Smoked Porter -- Pub Ale -- Watermelon Wheat
Planning:
Gone But Not Forgotten:

www.IronOrrBrewery.com

 
Reply With Quote
Old 04-04-2007, 09:17 PM   #8
GregKelley
Recipes 
 
Feb 2006
North Royalton, OH
Posts: 165
Liked 7 Times on 6 Posts


Quote:
Originally Posted by Dude
Are you using too much black patent? Black patent can be really bitter--almost astringent.

I also think the hard water has more to do with it than people here are saying. I had the exact same problem when I brewed an extract stout.
I haven't used black patent in my last 2. But I will watch for that in the future.

 
Reply With Quote
Old 04-04-2007, 09:43 PM   #9
lovemyhomebrew
Recipes 
 
Apr 2007
Posts: 18

I am by no means an expert brewer, but i have brewed a couple decent stouts a couple yeras back using fuggel hops. The fuggel hops offered a perfect balance of of biterness.

 
Reply With Quote
Old 04-04-2007, 09:47 PM   #10
Tophe
 
Tophe's Avatar
Recipes 
 
Jan 2005
Kalamazoo MI
Posts: 538
Liked 1 Times on 1 Posts


I was recommended to use .25 lb of black patent in a brew, much more will not be good for flavor.


__________________
"Give a man a beer, he'll drink for a day. Teach a man to brew, he'll drink for a lifetime"

All tanks are empty :(


Drinking: A two year old keg of Eff'd up MawN Lower Beer I made !
TindleKrauft Brewing

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Whirlfloc and Porters and Stouts mgo737 Recipes/Ingredients 7 09-18-2009 02:56 AM
Porters and Stouts: Soy Sauce Flavor Torchiest Recipes/Ingredients 12 10-30-2008 03:05 AM
Stouts Porters and Milds - All Extract blisterman Extract Brewing 8 10-23-2008 06:35 PM
What to do for a winter beer if you're not into Porters/Stouts? rockout Recipes/Ingredients 13 07-29-2008 03:09 AM
Good Porters & Stouts? Torchiest General Beer Discussion 14 11-28-2006 05:55 AM


Forum Jump