help with cedar deck finish - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Community > General Chit Chat > help with cedar deck finish

Reply
 
Thread Tools
Old 06-03-2011, 03:24 AM   #1
lschiavo
HBT_LIFETIMESUPPORTER.png
 
lschiavo's Avatar
Recipes 
 
Sep 2009
Surrounded by Yoopers
Posts: 4,555
Liked 1029 Times on 699 Posts



I built a small deck last year with some beautiful reclaimed western red cedar. I prefinished everything with Penofin. Less than a year later it looks like $hit. Store told me to wash off the black stains with oxy clean. It works but takes off the finish too. I am totally willing to spend some $ for the good stuff (thought I did). Any recommendations for refinishing?

 
Reply With Quote
Old 06-03-2011, 03:44 AM   #2
bengerman
Recipes 
 
Feb 2011
Redmond, Washington
Posts: 718
Liked 14 Times on 12 Posts


oh yes. what looks like crap now? is the stain fading, peeling, or just wearing off?
did you use the blue can or red can penofin? do you have a preference between something with or without a sheen? how is the weather there around now (temp and humidity)?


here's the short story:
since you have a transparent, oil based stain on there now, your best bet is to stick with oil.
if you want to use a different transparent stain, you'll have to remove all of the penofin, either by sanding or by the use of a chemical stripper.
if you don't want to remove the penofin, you'd have to go to a semi-transparent or semi-solid stain, also oil based.

 
Reply With Quote
Old 06-03-2011, 04:04 AM   #3
Dunerunner
 
Dunerunner's Avatar
Recipes 
 
Jul 2010
Florence, OR
Posts: 795
Liked 15 Times on 14 Posts


I use Sikkens DEK. Works great, looks great, holds up to the Pacific Nortwest Coastal environment. http://www.sikkens.us/en/Products/De...DEKFinish.aspx

bengerman Likes This 
Reply With Quote
Old 06-03-2011, 04:25 AM   #4
bengerman
Recipes 
 
Feb 2011
Redmond, Washington
Posts: 718
Liked 14 Times on 12 Posts


Quote:
Originally Posted by Dunerunner View Post
I use Sikkens DEK. Works great, looks great, holds up to the Pacific Nortwest Coastal environment. http://www.sikkens.us/en/Products/De...DEKFinish.aspx
good call, exactly why I asked about the sheen. one of the best products for decks around. One cool thing is that you can use their Cetol Maintenance product periodically, so you don't have to do a full on refinish as long as you keep up on it.
it is supposed to be applied to all six faces of every board, though. if you can get the top, bottom, and sides, it'd probably be OK, but if there was ever an issue, sikkens wouldn't cover you.

their SRD is pretty good as well, but you'll probably be looking at 2 years between maintenance coats. quite a bit cheaper than the DEK though.


big thing most people don't realize is to let your deck dry out really well if you pressure wash (around here that's anywhere from 5 days if it's frying hot to about 2 weeks in the LATE spring/early summer)

EDIT: i completely skipped over your black spots. those sound like mildew spots, which is usually from applying your stain when the wood is wet, or from excess moiture trapped below the deck (deck too close to the ground without proper ventilation) TSP and bleach will take care of that way better than Oxyclean. 30 seconds cleaner is a convenient pre-mixed tsp/bleach solution that's usually pretty inexpensive, find it at the Ace or true value - home despot and bLowes don't sell it.

 
Reply With Quote
Old 06-03-2011, 02:47 PM   #5
lschiavo
HBT_LIFETIMESUPPORTER.png
 
lschiavo's Avatar
Recipes 
 
Sep 2009
Surrounded by Yoopers
Posts: 4,555
Liked 1029 Times on 699 Posts


Thanks for the help guys. Here are a few pictures that may shed some light:

Here is the deck:


Here is a shot of the black staining:


Here is where I tried the Oxy on the steps and skirt board. It still has some color but it seems to have removed a lot of the finish.


This wood stood 60 years as football field lighting posts. I had it sawed and it seemed bone dry then plus it sat for a year indoors before I even used it. I prefinished everything with two coats and it sat in a nice warm garage for at least a few weeks before it was installed (so I dont think moisture under the finish was a problem). I do want to stick with an oil based finish. I am going to get some TSP today and see how that works. Any other suggestions?

 
Reply With Quote
Old 06-03-2011, 04:09 PM   #6
Homercidal
Licensed Sensual Massage Therapist.
HBT_MODERATOR.png
 
Homercidal's Avatar
Recipes 
 
Feb 2008
Reed City, MI
Posts: 30,668
Liked 4774 Times on 3222 Posts


I've used a powerwasher on our treated deck. Not sure how that would affect the Cedar. Seemed to clean ours up pretty good. Almost like new. I'm sure you'd at least have to be careful of the amount of pressure.

 
Reply With Quote
Old 06-03-2011, 04:40 PM   #7
lschiavo
HBT_LIFETIMESUPPORTER.png
 
lschiavo's Avatar
Recipes 
 
Sep 2009
Surrounded by Yoopers
Posts: 4,555
Liked 1029 Times on 699 Posts


Quote:
Originally Posted by Homercidal View Post
I've used a powerwasher on our treated deck. Not sure how that would affect the Cedar. Seemed to clean ours up pretty good. Almost like new. I'm sure you'd at least have to be careful of the amount of pressure.
Good idea. I am going to try the pressure washer. I have some Oxalic acid and am going to pick up some TSP and experiment a little.

The finish has really faded and does not look close to what it looked like last fall.

From a previous post:
It was the blue can. That is all the local store had.

 
Reply With Quote
Old 06-03-2011, 04:48 PM   #8
Homercidal
Licensed Sensual Massage Therapist.
HBT_MODERATOR.png
 
Homercidal's Avatar
Recipes 
 
Feb 2008
Reed City, MI
Posts: 30,668
Liked 4774 Times on 3222 Posts


I'd test an inconspicuous area first... TSP is supposed to be good for cleaning stuff like driveways, but I don't know what it would do to wood.

The powerwasher we borrowed worked so well that I am considering buying one for myself. Just be careful that you don't carve the wood. The washer I used could be dialed in to a tight stream and you could actually remove a fair amount of wood with it. Start low and work your way up. A small deck like that should not take too long. I bet you could rent from for not much money. And it might work best with a chemical pre-treatment (less pressure, better stain removal).

 
Reply With Quote
Old 06-03-2011, 05:46 PM   #9
lschiavo
HBT_LIFETIMESUPPORTER.png
 
lschiavo's Avatar
Recipes 
 
Sep 2009
Surrounded by Yoopers
Posts: 4,555
Liked 1029 Times on 699 Posts


Quote:
Originally Posted by Homercidal
A small deck like that should not take too long. I bet you could rent from for not much money. And it might work best with a chemical pre-treatment (less pressure, better stain removal).
Are you saying your deck is bigger than my deck? I always thought it was how you used your deck, not the size, that mattered I have a nice pressure washer...I just kind of forgot about it.

 
Reply With Quote
Old 06-03-2011, 06:30 PM   #10
bengerman
Recipes 
 
Feb 2011
Redmond, Washington
Posts: 718
Liked 14 Times on 12 Posts


Quote:
Originally Posted by Homercidal View Post
I'd test an inconspicuous area first... TSP is supposed to be good for cleaning stuff like driveways, but I don't know what it would do to wood.
TSP and bleach is pretty much the industry standard for cleaning wood prior to staining. it's what Sikkens recommends in all of their staining brochures and all of their training classes.

do be careful of that glass though, TSP is darn near impossible to get off of glass.

that picture looks les like mildew than your description, are there little black specks in there that aren't coming out in the photos, or is there just general discoloration? looks like just algae/general grime or UV damage. your boards are very close together, does the deck have any pitch to allow for water runoff?

if the TSP/bleach and/or pressure washing don't clean that up, either a floor sander or a wood brightener containing oxalic acid will get it back to bright.

for my own info, which penofin did you use? blue can or red?

 
Reply With Quote
Reply
Thread Tools



Forum Jump