hydrometer question - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > hydrometer question

Reply
 
Thread Tools
Old 05-23-2011, 02:46 AM   #1
jacobmarley
Recipes 
 
May 2011
chattanooga, Tennessee
Posts: 78


I think I heard a friend tell me about a hydrometer that can stay in your fermmenter while it's fermenting. Is this true or did I dream it? If it is true, anyone have good/bad opinions/advice in them? Any feedback would be greatly appreciated.!

 
Reply With Quote
Old 05-23-2011, 03:00 AM   #2
samc
Recipes 
 
Aug 2008
Portland OR
Posts: 5,387
Liked 63 Times on 59 Posts


Any hydro can be left in your fermenter if you choose to do so. They also sell a set of ping pong like balls with gravity numbers on them to approximate the gravity.

 
Reply With Quote
Old 05-23-2011, 03:12 AM   #3
jacobmarley
Recipes 
 
May 2011
chattanooga, Tennessee
Posts: 78

Ah. Much thanks! Will try this with my next batch.

 
Reply With Quote
Old 05-23-2011, 03:27 AM   #4
emjay
 
emjay's Avatar
Recipes 
 
Jan 2011
Toronto, Ontario
Posts: 12,792
Liked 1719 Times on 1606 Posts


Edit

 
Reply With Quote
Old 05-23-2011, 07:34 AM   #5
emjay
 
emjay's Avatar
Recipes 
 
Jan 2011
Toronto, Ontario
Posts: 12,792
Liked 1719 Times on 1606 Posts


There are some issues with doing that though, even if you read it through the fermentor (which is tricky even with a glass carboy or better bottle.)

Main thing is that getting an accurate reading is pretty tough for a number of reasons. Krausen is going to make it float at the incorrect level, and even when the krausen falls, it will leave a residue (identical to the krausen ring left on the inside of the fermentor), which will add weight to the hydrometer (which is sensitive by design) and make the gravity appear lower than it actually is. And that's assuming the brown krausen residue doesn't obscure the numbers completely. You can also forget about doing this while dryhopping.

Perhaps the biggest problem though (because it's hard to detect) is CO2. CO2 being produced can raise the hydrometer higher than it should be. Even when using the hydrometer on a sample, it's considered important and good practice to give the hydrometer a little spin to get the bubbles off the bottom of it, and that's after only being in the beer a few seconds! In the fermentor, bubbles are bound to collect on the bottom of it and raise it higher than it should be, giving an artificially high gravity reading.

Also, during an even SLIGHTLY active fermentation, the natural convective movement of the beer in the fermenter will also push it upwards.

Mainly though, I just don't see the point. After my first few batches, I stopped constantly checking the gravity - it's unnecessary, and exposes the beer to further oxygen and contamination. In fact, every experienced brewer I know personally is the same way. Unless you are a commercial brewer whose bottom line depends on high turnover (and have fermentors capable of drawing off samples in a very sanitary and even oxygen-free way), it's usually best to let a beer stay in the fermentor 3 or 4 weeks, and you KNOW a typical beer is going to be done by then. Then, when it gets bottled, kegged, or racked to another vessel, it's a great opportunity to also draw off a sample to check the final gravity, in order to make sure there weren't any serious underattenuation problems (very rare when you're patient) or overattenuation problems (sign of an infection), as well as to just keep track of the final gravity and determine your ABV.

Basically, I check my gravity 3 times - pre-boil, OG, and FG. In my experience, it's pointless and even detrimental to mess with your beer otherwise - which, for reasons stated above, will be necessary even if you leave a hydrometer (or similar floating instrument) in the fermentor.

 
Reply With Quote
Old 05-23-2011, 08:12 AM   #6
jetmac
HBT_SUPPORTER.png
 
jetmac's Avatar
Recipes 
 
Aug 2010
Mcdonough, Ga
Posts: 1,140
Liked 36 Times on 18 Posts


+1 /\
.....i
.....i
.....i
__________________
Wayne Gretzky-"100% of the shots you don't take, don't go in

Revvy>>You shouldn't worry about ANYTHING, you didn't hurt the yeast, they know what they need to do, they want to eat all that sugar they are swimming around in. They want to pee alcohol and fart co2, it's their nature.

Bobby_M>>I flood the keg with CO2 for one minute with the lid off, rack the beer in to the bottom gently, seal it, flood it, vent it. If there's still O2 in there after that, F it.

 
Reply With Quote
Reply
Thread Tools



Forum Jump