I recently received a brand spanking new kegcowboy.com regulator that will not work for my setup. I currently have a dual regulator on my kegerator, and one of the two reg bodies is pretty crappy. I was hoping to swap the crappy one with this new keg cowboy reg, but the keg cowboy regulator has right hand threads on the high pressure ports, where most regulators I am familiar with have left hand threads !!!
Suffice it to say, I was pissed! If you have a single body regulator with LEFT HAND THREADS on the co2 inlet pipe ( High Pressure pipe that attaches to the bottle), that is comparable to this one
I'd love to swap you.
When I say comparable, I obviously don't mind if it is used, I just want to have some finer control over the pressure. My current "crappy" reg pressure starts at 10 psi and is hard to fine tune the pressure. If it is like a taprite or similar with single PSI increments on the dial (and left hand threads of course) I would love to trade you.