I think this
pretty much says it all... First section covers why, the rest of the info is just gravy...
Why Yeast Need Oxygen
Yeast use oxygen for cell membrane synthesis. Without oxygen, cell growth will be extremely limited. Yeast can only produce sterols and certain unsaturated fatty acids necessary for cell growth in the presence of oxygen.
Inadequate oxygenation will lead to inadequate yeast growth. Inadequate yeast growth can cause poor attenuation, inconsistent or long fermentations, production of undesirable flavor and aroma compounds, and produces yeast that are not fit for harvesting and re-pitching.
How Much Oxygen?
Oxygen requirement is variable depending on: yeast strain employed, original gravity of wort, and wort trub levels.
Some yeast strains have higher oxygen requirements than others. It is generally safe to assume that you need at least 10ppm of oxygen. 10ppm will supply adequate oxygen in most situations. Over-oxygenation is generally not a concern as the yeast will use all available oxygen within 3 to 9 hours of pitching and oxygen will come out of solution during that time as well. Under-oxygenation is a much bigger concern.
High original gravity (>1.065) wort, in addition to increasing osmotic stress on yeast, can cause problems with achieving adequate levels of dissolved oxygen. As the gravity of wort increases, solubility of oxygen decreases. Increased temperatures also decrease the solubility of wort.
The unsaturated fatty acids found in wort trub can be utilized by yeast for membrane synthesis. If wort trub levels are low, yeast will need to synthesize more of these lipids and therefore will require more oxygen.
Methods of Aeration / Oxygenation
Homebrewers have several aeration/oxygenation methods available to them: siphon sprays, whipping, splashing, shaking, pumping air through a stone with an aquarium pump, and injecting pure oxygen through a sintered stone. We have tested all of these methods using a dissolved oxygen meter and have found that, when using air, 8 ppm of oxygen in solution is the best that you can achieve. Injecting oxygen through a stone will allow much higher dissolved oxygen levels. The chart below shows methods tested and the results.
Method DO ppm Time
Siphon Spray 4 ppm 0 sec.
Splashing & Shaking 8 ppm 40 sec.
Aquarium Pump w/ stone 8 ppm 5 min
Pure Oxygen w/ stone 0-26ppm 60 sec (12ppm)
It was concluded that pumping compressed air through a stone is not an efficient way to provide adequate levels of DO. Traditional splashing and shaking, although laborious, is fairly efficient at dissolving up to 8 ppm oxygen. To increase levels of oxygen, the carboy headspace can be purged with pure oxygen prior to shaking. The easiest and most effective method remains injecting pure oxygen through a scintered stone.